0
What else can I help you with?
How do you bleed brake fluid in a Ford Focus?
Use a helper to pump the Ford Focus brake pedal several times. While holding the pedal down, open a wheel bleeder valve and let air and fluid out. When the pedal reaches the floor, close the valve and pump the pedal again. After several times, the air will be out of that area, move to another wheel and repeat the process.
How do you bleed the clutch on an S-10?
pump the clutch pedal several times it should fix your problem
1981Corvette lately has had troble starting up you find you have to pump the gas pedal like 6 times where as before you would only pump two and a half times?
Could be the accelerator pump of choke not adjusted properly
You just changed your front disc brakes on a 04 santa fe But the pedal seems to be to loose did you miss something?
pump the pedal a few times then check your brake fluid level it should go down a little bit then start the car and let it run and continue to pump the pedal.
Why is the brake pedal solid on your 1996 punto diesel?
The most likely cause is the vacuum pump has failed. press the brake pedal a few times with the engine off keep your foot on the pedal and start the car your foot should drop slightly if it does not either the vacuum pump or the servo itself is faulty.
How do you test the vacuum pump on a 1997 7.3 diesel?
easiest way to test vacuum pump is , with engine off, pump brake pedal until pedal goes hard keep pressure on brake pedal and start engine if vacuum pump is good, you will feel the brake pedal go softer so you don't have to use as much effort for pedal to be depressed
When you try to start your truck you have to pump the gas pedal a bunch of times to get it started you have efi?
If you have EFI, electronic Fuel Injection, pumping the pedal will do little good because there in no "pump" to pump fuel into the intake, as with a carburetor. Punctuation sometime helps. Using 'texting' style communicates information poorly.
You have to pump your clutch pedal a few times for the clutch to engage on your Hyundai Excel 1997 how do you fix?
you need to bleed your clutch fluid
How do you test hydraulic brakes for leaks?
if the vehicle has hydraulic brakes, pump the brake pedal three times. them apply firm pressure to the pedal and hold for five seconds. the pedal should not move. if it does, there may be a leak or other problem. get it fixed before driving.
How do you bleed the brakes on a 95 lumina?
With a helper, pump the brake pedal on the 95 Lumina several times then hold it down. Open a bleeder valve at one wheel, and let the air and fluid out until the pedal reaches the floor. Close the valve and pump the pedal back up. Repeat until there is no air in the fluid, then go to the next wheel.
How do you bleed a ford ranger 5 speed transmission 3.0 1997?
Remove the dust cover. Open the bleeder. Allow fluid to come out Have someone press clutch pedal. When pedal at the bottom, close bleeder. Pump pedal 5 times. Add fluid. Repeat until good pedal.
How do you bleed brakes on 2005 F250 diesel?
Have a helper pump the brake pedal several times then hold it down. While the pedal is being held, loosen the bleeder valve at one wheel caliper, letting fluid and air escape until the pedal touches the floor. Close the valve, pump the pedal up again and repeat until no more air shows. Repeat the process for each wheel.
