EVO sensor. Also known as steering speed sensor.
how is it to replace fuel pump on 2000 Chevrolet truck
That depends on the gear ratio of the truck. It is hard to answer your question with out that infomation. SORRY
It is in the back of the engine where the distributor used to go. Right beside the oil sending unit. It is hard to see. One small bolt holds it in.
It is right behind the distributor, It is hard to get to.
Bumblebee - Chevrolet Camaro (classic) Autobot Jazz - Pontiac Solstice (Hard Top) Autobot Ratchet - Hummer H2 Ironhide - GMC TopKick medium-duty truck Optimus Prime - 1994 Peterbilt
It is right behind the distributor. It is hard to get to and see but it's there.
Possible, but not worth the effort.
Hard Truck Apocalypse was created on 2005-12-08.
Either the power brake booster is bad, or it don't have any vacuum going to it. That is the part that the brake master cylinder is bolted to.
There are 3 screws holding the plastic cover on it .. it is hard to find the one on the left (when you are facing the truck) but it is a easy change once you locate the screws.
no, not hard to paint but hard to paint and make it look like a factory paint job. You need the proper equipment, skill, and knowledge to do it right. Preparation is also very important.
It will be on the inside right bottom side of radiator. HARD TO SEE.