its the theft lock system. turn the key to "on "for 10 mins ..yes 10 mins. then turn off for 5 secs ...giver hell. flashes up everytime...the theft system disables the fuel injectors.the above process resets the computer...
The 2005 Chevrolet Malibu axle nut torque specification is 60 pounds. Over torque in the axle nut will cause the will bearing to fail.
Start with the basics. Is it getting fuel and spark? If no fuel then check the fuel pump and filter. For no spark check the cap, rotor, coil, and coil wire.
Not really as long as you have the correct size 12 volt battery the CCA rating will not effect the batteries initial ability to start the engine. It may not be able to turn the engine over as long as a higher rated battery but it will start the engine if all is as it should be. A sluggish start sounds like you may have a starter going bad.
If the engine cranks over but fails to start check: No fuel in tank clogged fuel filter Failed fuel pump. No spark. The unit has OBDII get the trouble codes read, the ECM can help report issues relating to a no start condition.
a little over 4 quarts
My 2005 aveo won't start
under the car is a check plug it is located on the drivers side on the transmission i square head plug start car open plug fluid should flow out of plug do not do not over tighten plug do not over tighten
battery. key circuit, or solenoid.
If your 2003 Malibu turns over but won't start despite having a new fuel filter and pump, consider checking the ignition system, including the spark plugs and ignition coils, as a failure here can prevent the engine from firing. Additionally, inspect the battery and connections to ensure they are providing adequate power. Finally, verify that there are no issues with the engine's air intake or any potential sensor failures, such as the crankshaft position sensor, which could affect starting.
In most cases, the engine will not fire or start if the clutch switch is bad. The key will turn in the ignition but there will be no turn-over or sound from the engine. If the engine turns over but doesn't start, there might be a problem with the fuel supply.
That engine needs fuel, compression and spark to start and run. You are missing one of those.
check and make sure you are getting spark to coils!!