answersLogoWhite

0

if your turn signals dont work but your hazards do...check the fuse behind the radio.it looks like your hazard flasher.(should be blue, mine was).if not, make sure that the wires are fully seated in the ignition module on your steering column(its right below the ignition, that you put your key in)..if there loose, get a zip tie and secure it on the ignition module..

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why do the brake lights work but not the parking lamps on a 1990 mustang and the dash lights do not work too but the turn signal lights on the dash work.?

Check the fuses.


Toyota camrey 1998 why wont my signal lights work?

Check the signal light fuse, the signal light relay, and the signal light switcher.


How do you run highbeams and fog lights on a 2007 mustang gt?

the fog lights work with the low beams , they wont come on with the high beams


Why would 3 of the signal lights on a 67 mustang work but the rear passenger side signal and brake light not work?

If it's not the bulb or the ground wire, check the connections. If all else fails, it's the turn signal switch.


Your turn signal wont work in your 1989 f150 and it keeps blowing fuses and brake lights will not work?

Believe it or not, I have had to disconnect the cig lighter in order for the tail lights to work. Sounds far fetched but it does work!


Why would your wont your turn signal work but your hazerds will and i replaced all the fuses?

Could be the control stick for the blinkers. If the lights work, try replacing the stick or checking out the signal path for that blinker


Turn signal issues with a 1968 Mustang Have new flashers in New headlight switch New turn signal switch have emergency flasher action No turn signal action when L or R is engaged Bad grounds?

It could be a bad ground, also check the fuses its a 14A Fuse in the top of the block and all the lights (if one light is out that side wont work)


Why wont my signal lights work I've changed the fuses several times and they still wont work on my 1997 Chevy Malibu?

did you change the flasher? it looks kinda like a film canister, under the dashboard by your feet


When it signal lights get wet they wont work how to fix this problem?

If signal lights fail to work when wet, first check the connections for corrosion or moisture buildup. You can use dielectric grease on the connectors to create a moisture barrier. Additionally, ensure that the housing is properly sealed to prevent water ingress. If the problem persists, consider replacing the signal lights with a more water-resistant model.


Why do truck turn signal lights work but not the turn signal lights on the trailer?

There are separate fuses for trailer signal lights in main fuse panel


Brake lights and signal lights work on your 1985 s-10 but the headlights parking lights radio intrument lights and horn wont All fuses are good Someone said mabye the relay but where's the relay?

on the back of the car


Why wont turn signals work on 2007 kia spectra ex?

If the turn signal lights come on but will not flash you have a defective flasher relay. Replace the relay.