0
What else can I help you with?
What causes a vehicle's RPMs to rev up while driving?
If you accelerate and the transmission shifts to a lower gear of the overdrive disengages the RPMs will increase. If the vehicle has a manual transmission a slipping clutch will cause the RPMs to increase if the clutch is defective.
What could cause a car to sputter and eventually backfire at high rpms only in 3rd 4th and 5th gear but not in 1st or 2nd?
It sounds like fuel starved. Try the fuel filter or the fuel pump.
The rpms on a Mazda mx3 1994 mine is set to high how can you get it lower?
don't accelerate as much or change up a gear
Why does rpm go higher before shifting gears on 1994 Honda Accord?
The engine is turning more revolutions at the lower gear. Once you shift into a higher gear the rpms drop.
What would cause a 1992 Mazda 929 to sputter and have no power when put into drive gear but idles fine?
You may have a faulty coil. Check mass air flow sensor
Do you use the fifth gear of a Geo Metro?
You most certainly do, it is called overdrive. You may be able to achieve high speeds in 4th gear, BUT you can also acheive those speeds in 5th gear but with lower RPMs, thus resulting in an increase in fuel economy
A gear with 40 teeth turns at 10 RPMs how many RPMs will the gear with 10 teeth turn?
In this particular sinerio , you would calculate the unit rate.To do so you simply divide 40 by 4 (10), then divide 10 by 4 as well. Therefor a gear with 10 teeth turns with 2.5 rpms.
What is the car speed at 1000 RPMs?
It depends on what type of car and what gear you are in
What is the fastest gear ratio for achieving maximum speed in a vehicle?
The fastest gear ratio for achieving maximum speed in a vehicle is typically the highest gear ratio, such as overdrive gear. This allows the engine to operate at lower RPMs while maintaining high speed, resulting in better fuel efficiency and top speed.
What should the rpm range be in 5th gear on a 92 geo trackermine runs at 3500 rpms at 60mph?
I have a 1992 Asuna Sunrunner. 1.6l 8 valve/ stock (yet). Runs about the same
How can I reduce the lugging noise at lower rpms on your 03 silverado?
Shift to a lower gear. Lugging will damage your engine and should not occur if you are in the proper gear for whatever you are doing. On your silverado if it is an automatic you should have a trailering button in the end of the gear shift to turn the trailering mode on and cause the vehicle to shift sooner when carrying a load even if you aren't pulling a trailer.
When to shift gears?
Engines work best in a certain range or RPMs (revolutions per minute). The time to shift is when you've moved outside that range. If the engine is spinning fast you change to a higher gear, if the engine is spinning too slow you shift to a lower gear.
