0
There are a couple of reasons this could occur.One could be that the temperature sender is defective and needs to replaced this is what makes the gauge on the dash show a reading.Two is if the temp sender is not defective then it could be a faulty gauge meaning the gauge needs to be replaced.Also a short in the wiring or bad connection can cause this.As long as you have normal heat temps when in the vehicle I would not think it is ur thermostat being bad.The only thing that may cause the needle to not be in the normal position is extreme cold but the gauge should show a reading.If the gauge does not move at all, I say it's more than likely the temp sender is bad in most cases.I would not rule out other issues but,most typical is the sending unit,and not the gauge or short or bad connection.I could elaborate on checking lots more but,this is alot to begin with.
What else can I help you with?
Why your temperature needle going up an down when you drive on the freeway and then at 55mph up stay mostly down?
Check your antifreeze level.
How is a speedometer needle moving when a car you moving with constant velocity speeding up and slowing down?
When a car is moving with constant velocity, the speedometer needle stays steady at a fixed position. However, when the car is speeding up, the needle moves clockwise indicating an increase in speed. Conversely, when the car is slowing down, the needle moves counterclockwise indicating a decrease in speed.
What causes the rpm needle to go up and down while driving?
The rpm needle fluctuates while driving due to changes in engine load and speed, which affects the engine's revolutions per minute. Factors such as acceleration, shifting gears, and variations in terrain can cause the engine to work harder or easier, resulting in the needle moving up and down. Additionally, fluctuations can occur due to issues with the throttle position, fuel mixture, or even problems with the vehicle's sensors or ignition system.
What is the motion of a needle of a sewing machine?
The motion of the needle in a sewing machine is vertically, rapidly up and down.
Why needle sinks down?
cause
How long would it take to chop down a full sized pine tree with a knitting needle?
You cannot chop a tree down with a knitting needle as the needle does not have a sharp edge. You could bore it down if you lived long enough.
What was the examples of law of motion?
1) What goes up, must come down. 2) What goes down, stays down. 3) What stays down is probably dead.
How high should the heating sensor get before going down in Pontiac Montana?
Mine stays at the first quarter, up from cold. I would add more coolant if the gauge is unstably going up and down at different speed. I think you may have a slow to open or sticky thermostat if you feel nervous as your engine warms up, and the temperature needle climbs and climbs, and starts to smell like roast duck with penzoil au jus...
What is the meaning of needle clamp?
The needle clamp is collar and screw device that holds the needle to the needle bar. The needle bar is the part that goes up and down as the machine sews and is in front of the pressed foot bar.
How does a needle fish keep its body temperature?
Needle fish are ectothermic, meaning they rely on external sources to regulate their body temperature. They warm up by swimming in the sunlit surface waters and cool down by diving into deeper, cooler waters. They also have unique blood vessels that allow for rapid heat exchange, helping them to maintain their body temperature.
What is the automatic bobbin winder?
Automatic declutch bobbin winder – which means the machine automatically stops the needle from going up and down when you are winding thread onto the bobbin. ... Needle up/down button – this button allows you to start and stop with the needle in the down position if it is highlighted.
What would the temperature be in a freezer that is turned down to low?
The temperature in a freezer that is set to low can vary, but it is typically around 0 to 10 degrees Fahrenheit (-18 to -12 degrees Celsius). It is important to monitor the temperature with a thermometer to ensure it stays at a safe level for storing food.
