answersLogoWhite

0

Chances are, this is happening because the belt is wet. Chrysler added a splash shield to these to prevent this from happening, but if water gets up in that area it can still occur.

I would replace your belt with a new one, and if the problem persists, I would contact a local Chrysler dealer and ask them.

User Avatar

Wiki User

17y ago

What else can I help you with?

Trending Questions
What does the service vehicle soon light mean on Pontiac aztek? Ford crown vic rear wheel? Your 99 windstar sounds like its pumping something in the engine when its sitting idle and today it made a loud noise and a really bad smell? How do you replace a manual transmission shifter knob on a 2004 ford ranger? 1988 Chevy pick up 350 ci tbi ran fine then then motor idol speed was high and then started stalling when you put it in gear what could it be? How do you change the HV battery air filter on a 08 Escape? Where is the 7 ignition coil on a e250 year 2001? P0441 evap leak does this cost a lot to fix you did replace the gas cap however the light came back on so you know that it is a leak somewhere in the EVAP system so you will need to get it fixed? How many quarts of oil for a 2008 jeep wrangler? Is the 3.73 gear ratio good in the 04 v10 excursion? Why won't the interior lights on your 2002 Mercury Mountaineer shut off? Is there a website that you can view rims on your car before buying? Will a 350 turbo transmission fit a 1992 GMC that has a 700R4? What is the factory size tire for a 97 Ford Aspire? How do you get hazards to turn off? You want to rollerize the bottom-end of a 1965 327 cid is it possible? Is a s-10 2.2 motor head the same as a 2.2 cavalier cylinder head? How many gallons of gas does a 2005 Ford Ranger hold? How do you replace the ignition switch key cylinder on the steering column on a 95 gmc vandura? Is the 2007 Honda CR-V front wheel drive rear wheel drive or four wheel drive?