No, that would indicate transmission problems, is it a standard or and auto?
Dead short to ground in reverse light circuit?
No
could possibly be the torque convertor. wiil it go if you give it some gas going from neutral to reverse or does it still stall ? check shift linkage for pinching a wire when shifted , good luck !
transmission filter not properly seated in the valve body, causing it to stall when engaging reverse gear, wouldnt have believed it if i personally hadnt experienced the exact same problem myself.
leveling kits
The 2003 Ford f250 did not come with an air cabin filter. There was a dealer install option but very few were ever put in.
Yes, you would put the water in the reservoir.
It might be a problem with your transmission because not all mx6's stall when you put it in drive or reverse.
If you mean each time you engage car in any gear forward or reverse & it immediately stalls - you have a bad torque converter. Start engine, put foot on brake, put car in NEUTRAL, if it DOES NOT stall, but it does stall if you repeat this test when you put car in drive or reverse = bad torque converter - It's called a "stall test"
Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?
youre lifting the clutch up to quick
Take it to your nearest car stereo retailer!