0
What else can I help you with?
How do you remove the ignition switch on a 1989 Chevy Corvette?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
Where is the fan relay switch on a 1991 corvette?
drivers side...in engine compartment..mounted next to radiator
Where is the fan relay located on a 94 Corvette?
The 1994 Chevrolet Corvette fan relay switch is located in the fuse box. The fuse box can be located in the engine compartment.
What would cause no spark at the spark plugs on a mercury 125 outboard?
The most likely cause would be the stator assembly. By disconnecting the cannon plug for the key switch harness, at the engine, you can isolate the problem to the engine, or the ignition switch / harness assemblies. With the harness disconnected, spin the engine over with a starter button, connected to the solenoid. If the engine now has fire, the problem is in the ignition kill circuit, (ignition switch, emergency kill switch, or harness assembly). If a no fire condition still exists, the problem is in the ignition system, on the engine itself. The stator, and related ignition components can be tested with a volt / ohm meter.
How do you replace a 1993 Corvette headlight dimmer switch?
How do I change the dimmer switch on my 1993 corvette?
What is a Corvette Vacuum Diagnostic Switch?
I am not a corvette mechanic, but I call BS on vacuum diagnostic switch.
How do you replace dimmer switch on 1977 corvette?
To replace the dimmer switch on a 1977 Corvette, first disconnect the battery to ensure safety. Remove the dashboard panel to access the dimmer switch, which is typically located near the headlight switch. Unscrew the old dimmer switch and carefully disconnect the wiring harness. Install the new dimmer switch by reversing these steps, making sure to reconnect the wiring securely before reassembling the dashboard.
Where is the oil pressure switch located on the engine on a 1998 corvette?
IT IS LOCATED IN THE REAR OF THE INTAKE... YOU HAVE TO REMOVE THE INTAKE TO CHANGE IT....
Where is the fuel pump reset switch on a 1989 Corvette automatic?
= Where is the fuel pump reset switch on a 1989 corvette automatic? =
1984 corvette you need to replace the door lock switch how do you get to the switch?
== ==
On a 1981 Corvette why would you have to hold the ignition switch in a partial start potion to keep the engine running If you let the switch go back to the on potion the electoral will stop?
check the fuse for ingnition
What Engine oil viscosity should be used in a 1979 corvette 350 engine?
I have a 79 vette 350 and i use 10w40. you might want to switch to synthetic, i hear it is better for older cars. but once you switch to synthetic, you can't go back
