answersLogoWhite

0

Your relay sensor is likely faulty

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Why does the odometer not work on a 1992 Chrysler New Yorker?

If the speedometer works but the odometer does not, the odometer has failed.


Why does your 1995 Chrysler New Yorker Third Brake Light not work?

Bulb is probably defective. Replace it.


Why doesn't my RPM gauge and temp gauge work?

why doesn't my rpm gauge and temp gauge, fuel gauge not work


Will the fuel pump cause the fuel gauge to not work?

No.


The fuel gauge is not working on 1994 Chrysler LHS?

Fuel Pump can be removed via the trunk of the car. There is a panel underneath the carpet that has fuel bolts that need to be removed and you can get to the fuel pump. Not difficult, just a pain because of where it is located and you have to work from inside the trunk of the vehicle.


Should the fuel gauge work with the engine off and key in run position?

Yes, key on, engine off, the fuel gauge should work.


How do you get the heat to work in a 1990 chrysler New yorker?

If the heat in your 1990 Chrysler New Yorker is not working, it could be due to a faulty thermostat, a clogged heater core, or a malfunctioning blower motor. You may need to have these components checked and repaired or replaced by a mechanic to restore the heat function in your car.


How can you fix the power windows on a 1990 Chrysler New Yorker?

If all do not work - check fuse in power distribution block under hood


Why would a 1991 Chrysler New Yorker start then die like it is out of fuel?

it is the anti theft. lock all the doors the unlock the door with the key. try with passenger door too. if this does not work it is some other problem with your anti theft system.


Why doesn't fuel gauge work on 2005 mustang?

why does the fuel gage on 2005 mustang don't work?


Why would the fuel gauge on a '86 E 150 not work on either fuel tank?

THE FUEL PUMP FLOAT HAS GONE BAD OR THE GAUGE NEEDS TO BE CHECKED


Do you need a fuel tank pressure sensor for gas gauge to work?

The fuel tank pressure sensor is for the EVAP system. It has nothing to do with the fuel gauge sending unit.