0
If your idle speed is adjusted properly (not too high), yet you can visibly see fuel entering the venturi, it may be because of check balls sticking within the circuits that aren't supposed to be working at idle, or internal gaskets leaking, or more often, a problem with the float level, which causes fuel to "spill" over the top, in an uncontrolled fashion. This causes CO levels at idle to skyrocket, which in turn will tax the catalytic converter (if equipped). This spilling is usually accompanied by an erratic "spitting" sound, and may cause erratic idle speeds as well. The cure for such a condition is inevitably a carb overhaul for best results.
What else can I help you with?
How do you get the idle down on a Yamaha badger?
To bring the idle down on a Yamaha badger is really easy. All you have to do is adjust the fuel settings on the carburetor.
Idle Screw On A 5.7 V8 350?
If it is a fuel injected engine then you can not adjust the idle, it is computer controled. There is no idle adjustment. If it is a carburetor then there is a small screew over by the throttle cable, down towards the bottom of the carburetor.
Why does your 83 Trans Am idle so high?
Should have a carburetor so all you have to do is turn the idle screw down some on the carb.
What would cause a craftsman lawn tractor to idle up and then down?
You need to adjust your carburetor.
What is a idle port in Car?
Rephrase, Idle air control, idle circuit carburetor or
How do you idle down your 1984 Chevy Caprice?
To idle down your 1984 Chevy Caprice, start by allowing the engine to warm up to operating temperature. Then, locate the idle adjustment screw on the carburetor, which is typically found on the side of the carburetor body. Turn the screw counterclockwise to lower the idle speed, monitoring the RPMs on the tachometer until you reach your desired idle level. Finally, ensure the engine runs smoothly and make any necessary fine adjustments.
How do you adjust carburetor on weed eater featherlite sst25?
The carburetor on a Weed Eater Featherlite SST25 is adjusted by turning the screws on the side of the carburetor. They control the idle mixture and idle speed of the engine.
How do you adjust the idle for a 1987 accord carburetor?
On the rear of the carb there should be a black plactic knob on a shaft with a spring. You will probably have to take the air cleaner housing off. Tightenen to idle up, loosen to idle down.
Why does your idle flutter?
Incorrect idle mixture (carburetor), or sticking IAC (idle air control), computer controlled engines.
Where is idle position sensor?
Idle air control valve sensor is located around the carburetor .
How do you set the idle on a 2003 Yamaha Big Bear 400?
To set the idle, adjust the carburetor.
Can the idle on a car be increased?
Yes, There is a screw on the carburetor or throttle-body that controls idle speed.
