0
What else can I help you with?
1993 Merc Topaz why are you getting Brake fluid to two wheels and not the other two?
Check the master cylinder first.
Diagram of brake lines on 1993 topaz?
need diagram of rear brake lines for 1993 mercury topaz
How do you reset the brake warning light on a 93 topaz?
Make sue brake fluid reservoir at top of master cylinder is filled to proper levelMake sure parking brake is fully releasedAnswerMake sue brake fluid reservoir at top of master cylinder is filled to proper level Make sure parking brake is fully released
How do you replace the brake pads on a 93 Topaz or Tempo?
take it to a dealer
What fuse controls the brake lights on an 1993 topaz?
The brake lights on a 1993 Topaz are typically controlled by the fuse labeled "STOP" in the fuse box. The fuse box is usually located under the dashboard or in the engine compartment. If the fuse is intact and the brake lights still do not work, you may need to check the brake light switch and bulbs.
How do you replace brake calipers on 1992 Mercury Topaz?
After the tire has been removed, this process is rather simple. You need to remove the hoses feeding brake fluid to the caliper. You will also need a hex key to remove the two to four bolts holding the caliper on. Once this is done, attach the hoses and/or lines to the new caliper, put the brake pads back on, slide over the rotor, and reattach with the two hex bolts. Be sure to add enough fluid and bleed the brake system before driving.
Where is the brake release for a 1994 Mercury Topaz?
your question is a little vague. If you are refering to the parking brake, if it is a pedal style brake, once it's set, you push down on it again to release.
Passengerside Brake line diagram for a 91 mercury topaz?
If you are replacing the brake lines ( metal ) then just use your better judgment. They do not have to follow the original route.
What are the release dates for Knight Rider - 1982 The Topaz Connection 1-16?
Knight Rider - 1982 The Topaz Connection 1-16 was released on: USA: 28 January 1983 Finland: 1 March 1984 West Germany: 1 October 1985
What kind of automatic transmission fluid for 1987 Mercury Topaz?
Dexron 3 will do just fine.
How do you check for a vacuum hose leak in a 1994 Mercury Topaz?
Do this OUTSIDE and be very careful!!! With the engine running, spray a litle starting fluid on vacuum lines that you suspect of leaking. Use short shots and don't let the fumes build up. That stuff is very flamable and is very dangerous if you get too much built up around a spark. Spray it on potential vacuum leaks and when you hit the place that IS leaking, the engine will speed up and/or run differently. Don't forget to check the vacuum assist brake and the intake manifold gaskets. But again, don't let the fumes build up. Use carb cleaner instead of starting fluid. It is not as volatile.
Where do you drain power steering fluid on a 1991 Mercury Topaz?
To drain the power steering fluid on a 1991 Mercury Topaz, locate the drain plug at the bottom of the power steering pump reservoir. Place a drain pan underneath to catch the fluid and then remove the plug to allow the fluid to drain out completely. Be sure to properly dispose of the old fluid according to local regulations.
