0
What else can I help you with?
What is wrong with a 94 ford ranger jerking - replaced mass air flow sensor and throttle position sensor?
vacuum leak
Where is the speed sensor on a Ford Ranger XLT or Mazda Drifter 2.5TD?
The speed sensor is located on the differential (rear end) I have a 99 Ford Ranger and have recently replaced one. EASY! Good luck!
Should I replace the crankcase sensor in 91 ranger - no spark - replaced DIS same thing - how easy is this?
no
Where is the speed sensor on a 1993 ranger 4 liter v6?
its on the rear of the transmission, it cant be replaced by itself, its part of the trans
Should a new motor be purchased when a crank shaft sensor needs to be replaced?
no no no my crank sensor when out on my truck ar 95k now i have 125k and she is still running good
Where is the rev counter sensor for a Ford Ranger 2.5TD?
Where is the ford ranger 2004 revcounter sensor conected
Change a throttle position sensor for 05 altima?
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
Why isn't my car running i have replaced the fuel injection sensor the clutch plat sensor fuil injection sensor n the coil pake n the brain box n your car still isn't running what else could it be?
take it to a mechanic. they'll know. I AM LINK....!
What needs to be replaced in a 1985 Pontiac Firebird if the car only stays running while foot is on gas and the throttle positioning sensor had been replaced?
it might be because the idle is low turn your idle up and it should stay running
What is a system too lean bank 1 on a mercury mystique?
Just had this problem. I replaced the oxygen sensor and it appears to be running fine.
Why would a 92 Cavalier start when it is cold but not stay running after a while?
mine did that and i replaced the crank shaft sensor,problem was fixed
1995 Ford Ranger turns over but no spark?
1995 ford ranger 4wd cranks over but no spark, replaced crank sensor Check battery power to coil connector, if that is good coil can be tested w/multimeter.
