0
What else can I help you with?
You should push hard on the accelerator when your vehicle is stuck?
NO
What is the push or pull on an object that can cause it to accelerate called?
Accelerator!?
Can you suggest slogans on save fuel?
There is an egg on your accelerator pedal. Push carefully!
While driving my car the accelerator would not work when you push the gas. I turned the car off and it did not start back up again. whats the problem?
sounds to me like a fuel pump if the engine continued to run but accelerator did not work then check for broken or disconnected accelerator cable both at the pedal and the throttle plate
Is it ok to push the accelerator on the first gear without moving?
You must be clearer on your query
To get out of a skid?
If its a front wheel drive car , you automatically push the accelerator but not to hard and turn into it not with it. A 4 wheel drive car you turn into it and press the accelerator and finally rear wheel drive you let go of the accelerator and turn into it
How do you make a passat go faster?
Push on the accelerator. Turbo charge the engine for more power.
What will cause a Chevy 350 V8 engine to cut off when the accelerator is pressed?
if it runs fine until you push the gas pedal the accelerator pump may be bad if it has a carb on it.
How can you blow air in or out to inflate a balloon?
To inflate a balloon, you can blow air into it by using your lungs to push air out of your mouth and into the balloon. Alternatively, you can use a pump to push air into the balloon.
How would a gravity hammer blow feel in real life?
it would feel like an explosion in front of you the force of gravity would push you back and would likely break some bones
Do white holes blow?
White-holes are a theoretical hypothesis that they are the opposite of a black-hole, in which case they would push matter out into space yes.
How do you shift a two speed axle on a 1969 ford f-600?
to shift from lo to hi range; press in on accelerator, pull control switch up, release accelerator and pause to allow axle to upshift. to shift from hi to lo range; press in on accelerator, push control switch down, release and press down on accelerator quickly. declutching is not necessary.
