answersLogoWhite

0

This has a vaccum operated servo; you probably have a vaccum line that has come off to the transfer case.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Your Chevy Blazer wobbles at high speeds?

how to change upper tie rod on 96 chevy blazer


Where is the power steering located 1988 Chevy blazer?

In a 1988 Chevy Blazer, the power steering pump is typically located on the front of the engine, mounted to the driver's side. It's connected to the steering gear via a high-pressure hose, allowing it to assist with steering. The pump is usually driven by a belt connected to the engine's crankshaft. You can find the fluid reservoir attached to the pump itself.


How do you put my2001 Chevy blazer into 2high?

Push the button that says "2 High".


Will speed sensor on Chevy S10 blazer cause it not to shift into high gear?

Yes, it could.


How do you replace an AC Orifice Tube in a 1995 Chevy Blazer?

it's in the high pressure side of the ac line


Why doesn't my 96 Chevy Blazer fan switch work on high?

its a relay in the dash or check ur switch


When engine starts the motor races real high then shuts down on a 97 Chevy s10 blazer?

t.p.s throttle position sensor


How do you flush a radiator on a Chevy Blazer?

Drain the blazer radiator. Refill with water. Open the heat on high, start the engine for a few minutes. Drain the system again Repeat this several times to get all of the old coolant out.


Can you start out driving on 4 wheel drive high in a 1986 Chevy Silverado Blazer?

Yes you can, but don't drive over 50 to 55 MPH


What might be the problem if your 1995 Chevy blazer starts but idles really high and when you hit the gas or put it in gear it dies?

YOU WILL DIE! have you check your IAC ??


How do you tell if the bright headlights are on for 2002 Chevy s-10 blazer?

There'll be an indicator light on the dash which comes on when the high beam circuit is energized.


1996 Chevy blazer fan switch wont work on high I replaced the relay and the fan switch and still no luck?

try a blower motor resistor