go buy some fuel. if it doesnt start check fuel pump.
did the parking brake get set, or the shoes adjusted too tight?
One thing that can make the cruise control stop working is if the contacts are shot or have become corroded. It is also possible that the fuse is blown or that the module needs to be replaced.
fuse #17 in the fuse box located under the rear seat bench
There are several things that can cause your 2003 Dodge Ram cruise control not to work. The most common cause is a blown fuse. A malfunctioning speed sensor can also cause the problem.
check the setting on the cruise control check the setting on the cruise control check the air flow meter is ok
Alot of cruise control units have a vacuum line going to them. Check this line see if there is any leaks or such.
fuse box, and connections at the servo under hood then vacuum cannister
Well maybe first you might wanna go and find the old owner and ask him whats up. If that doesnt work then maybe try to just shake and turn the key at the same time or just push in lttle harder
I was researching that very question. As I searched I replaced the clock spring, the buttons on the wheel, the switch on the bottom of the brake master cylinder. Then after all that I was made aware of a recall notice for the electrical link to the cruise control from the bottom of the brake cylinder. On mine there were 3 in-line fuses. I replaced that with a junk yard one and I got my cruise back. Hope that helps.
check the fuse... cruise control is on the same fuse so if cruise doesnt work then its a simple fix. if not then find horns behind the facia (need to take off skidplate) and check if they receive power
02 cadillac deville wont crank or start the entire dashboard illuminates and everything work when the switch is on seems like it wants to crank but doesnt. I had a problem for years with my 1991 Caddy and kept changing starters for a while. My problem was that I wasn't getting a good read on the security chip in the key. Next time it happens: turn it off, take the key out, wait at least three minutes and try again. Check your manual to see if that is still the procedure. By the way I decided to live with it. Every start is a roll of the dice.