answersLogoWhite

0

You need to change the input and output sensors on the tranny

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Why a 2003 Chrysler pt cruiser automatic transmission would not shift?

If the transmission computer detects a malfunction it defaults to second gear. It will have codes stored. Other causes include low fluid,and internal failure.


Where is the shift solenoid on a 2003 turbo pt cruiser?

The solenoid pack is on the front of the transmission case below the cooler hoses.


If the transmission fluid is low will first to second gear shift be delayed?

No it will shift slow.


What causes a Volkswagen golf with an automatic transmission not to shift the RMP races after second but it just wont shift?

A seized up transmission can cause a Volkswagen Golf with an automatic transmission to not shift and racing RMPs after second. A worn gear can also prevent shifting.


What are the function of the buttons called ECG power and second start in a Toyota Land Cruiser prado KZJ95?

ECG Power control the shift points for the automatic transmission. Push it in and your transmission will shift at a height RPM. It is good for towing. 2nd start is handy when you are in the snow and you are spinning your tires. It will force the transmission to start in 2nd gear making it more difficult for the engine to spin the tires from a stand still.


What causes the automatic transmission to shift hard from first to second gear on a 1999 Nissan Frontier?

A bad transmission gear can cause your 1999 Nissan frontier to shift hard. Low transmission fluid can also cause the transmission to shift hard.


What tells the transmission to shift to second gear on your 1989 Dodge Caravan?

Many things are inputed to tell the tranny to shift. The Solonoid pack executes the shift, and the transmission control module tells it when to shift. A good resouce is www.allpar.com.


Where is the transmission range sensor on a 2008 pt cruiser located?

On a 2008 PT Cruiser, the transmission range sensor, also known as the neutral safety switch, is typically located on the side of the transmission, near the transmission linkage. It is usually mounted on the transmission case and connected to the gear shift mechanism. To access it, you may need to lift the vehicle and remove any necessary components for better visibility and reach.


Car won't shift from first to second?

Transmission problem, you have to replace or get it repaired.


Why wont your 93 deville shift out of second gear?

A 93 Deville that wont shift from second gear has most likely got an internal transmission problem. Unless the linkage is mis-adjusted, then the problem is onside of the transmission.


How many times does a turbo 400 transmission shift?

A Turbo 400 transmission typically has three forward gears and shifts a total of two times as it transitions from first to second gear and then from second to third gear. It operates in a simple three-speed configuration, meaning it does not have overdrive or additional gears beyond these three.


Why gmc vandura does not shift after second gear?

change your transmission fluid and transmission filter if the problem persists then your transmission is most likely no good.