0
What else can I help you with?
Where is the ground wire for the dash cluster on a 1985 Corvette?
== ==
How do you get your 2003 F150 to start after replacing the instrument cluster?
To get a 2003 F-150 Truck to start after replacing the instrument cluster the cluster will have to be re-programmed. A dealer or possibly a locksmith can reprogram an instrument cluster.
What is an ip harness on a 1987 Corvette?
instrument panel,or guage cluster
How do you determine if the instrument cluster is causing a drain on the battery in a 1987 corvette?
== ==
How do you fix odometer on 1984 Corvette?
To fix the odometer on a 1984 Corvette, first, remove the instrument cluster from the dashboard. Check the odometer gears for any signs of wear or breakage, as these are common failure points. If the gears are damaged, they will need to be replaced; you can often find replacement gears online or at auto parts stores. After replacing the gears, reassemble the cluster and reinstall it in the vehicle, ensuring all connections are secure.
What could cause the dash cluster not to work except for the gas gauge in a 87 corvette?
led lights inside cluster
How do I repair 1994-96 C4 Corvette lcd dash cluster?
how do i reset the sensor on the instrument cluster on a 1984 corvett?
Will a 1984 Corvette dash cluster work in a 1985?
It should, but the 1985 dash cluster was easier to read, Eckler's offers a reasonably priced rebuilding service, if you have the original.
What is the easiest way to change the speedometer cable on a 1978 corvette?
There is no easy way. The instrument cluster will have to be removed.
In my 1984 Chevy Corvette the speedometer and gas gauge and everything else wont work if you push in on a certain spot it works any ideas?
It is most likely a poor contact on a printed circuit board in the cluster. You would have to disassemble the cluster and clean the boards with alcohol. Mine turned out to be a contact on one of the boards that had never been soldered.
How do you reset a 1991 corvette instrument cluster after you have installed a new one My tackometer and gauges don't work?
Did you replace it with the correct cluster ? the later ones are not compatible. You can replace the circuit board with a new one
How do you get the car to run after replacing the instrument cluster in your Mitsubishi endeavor?
The Engine Control Module (ECM) probably has to be flashed to relearn the new cluster. This is a job for the Mitsubishi dealer.
