0
I have seen a 1950 Chevy pickup put on a mid seventies chassis. The 66 cab on a 92 frame should be easier just measure the width length and height differences to see if any shims need to be made. ( the 50 pickup used short lengths of pipe to accommodate height differences) These were used at the mounting points of course. If you are trying to get front disc brakes a 71 or 72 front suspension should bolt right on to the 66, besides if you have the coil springs already it is the best ride you can get. If you just need a rebuild on all of your components my opinion is that the 66 has a much better frame and suspension.
What else can I help you with?
Where is the gearbox plug for a 1966 Chevy pickup?
Maxbox 12
1966 Chevy pickup key starts it but does not turn it off?
Could be a bad ignition switch....
How do you attach the accelerator pedal assembly to the carburetor in a 1966 Chevy C10 pickup with a 350 engine?
with rivets
1966 Chevy pickup with a 283 motor what is the firering order?
1, 8, 4, 3, 6, 5, 7, 2.
How do you install the bolt on the bottom of the front fenders on a 1966 mustang I have the square bolt and hole but can't see how to get in the hole?
the nut is in the frame the nut is in the frame
Are bodies and frames of a 1966 and 1967 Buick Skylark Convertible interchangeable?
the front frame horns are different
Is a 1966 elcamino frame same as a 1966 wagon frame?
Yes.
Where can someone buy a locking differential for a 1966 Chevy c10 pickup?
Try an auto parts store that specialises in 4 wheel drive equipment.
Where is the hood release on a 1966 Chevy Chevelle?
under the front bumper just above the license plate.
Will a 1966 international travel all windshield fit a 1966 international pickup?
yes
Setting timimg on 250 1966 Chevy truck?
what is initial timing on 1966 chevy 250
What newer truck frame will fit a 1965 Chevy C10 truck?
A direct bolt in replacement, the 1966 would work. After that nothing would be a direct bolt in with out fabrication.
