Yes, I've got a 307 running 305 heads in my old truck. I read somewhere it's actually worth a few extra horsepower
Yes you can.
Yes, they should fit ok. 305 heads should bump up the compression a little.
Yes, they will fit on the block. The larger combustion chambers of the 307 heads will probably reduce the compression ratio by a fair amount, reducing power output.
Yes they will, but 305 heads have a smaller combustion chamber so it may raise your compression ratio.
no I respectfully disagree. I am running 305 Chevy TBI heads on my 1971 Chevy 307 and all is very well.
This is 305:|And this is 307:|
it all depends on the head chamber volume of the 307 heads and the 350 heads that are being replaced. if the 307 heads have a smaller chamber volume then yes, they will bump up compression.
Yes, a 283, 305, 307, 327 etc will fit. You should be able to use small block motor mounts from 1966
Yes they will. The bore is 3.785 so they wont hit
307 pistons are 3.875" diameter. 305 pistons are 3.736". It might be possible to bore a 305 large enough to accept the 307 pistons, but the wrist pin location would be .230" off because of the different stroke. In short, no.
Estimating horsepower for a 307 cubic inch engine bored 0.040 over with 305 heads, roller rockers, and a 268 cam typically yields around 250 to 300 horsepower. The actual output can vary based on factors such as tuning, exhaust, and intake systems. The combination of the larger displacement, improved airflow from the 305 heads, and the performance camshaft can significantly enhance the engine's performance. For precise numbers, a dynamometer test would provide the most accurate measurement.
There is basically no difference. 305 is a Chevy engine and the 307 is a Cadillac engine. They are both the same and assembled by same company Well, on the other hand, it depends on how you look at it. The 305 Chevy is a 265 stroked with a 350 crank. The 307 Chevy is a 283 stroked with a 327 crank. In theory, the 305 should produce it's best torque at a lower rpm than the 307. However, the 307 should be able to rev higher and produce a higher peak horsepower. Kinda depends on what you need it for. There is also a 307 produced by Oldsmobile that is a V8 engine. It shares no other commonalities with a small block Chevy.