answersLogoWhite

0

Yes there is... It's call a TUNE-UP...

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

On a 1987 Chevy Corsica the accelerator has always been hard to push now the pedal is sticking how do you fix this?

WD-40


How do you fix the brake lights on a 2001 f350?

Check the fuse, bulbs or there is a push button switch above the brake pedal that may need align or replace


How do you fix my brake light that is glowing but not getting brighter when i push the brake on my Oldsmobile alero 2003?

Check the brake pedal switch. Check the bulbs. Check the grounds.


How can I fix a stripped bike pedal?

To fix a stripped bike pedal, you can try using a pedal tap to re-thread the crank arm. If that doesn't work, you may need to replace the crank arm or the pedal.


Brake lights stuck on?

brake light switch at the top off your brake pedal the little rubber bumber is worn out or the switch is out.... very easy fix


Why is my bike pedal creaking and how can I fix it?

Your bike pedal may be creaking due to a lack of lubrication or loose components. To fix it, try applying lubricant to the pedal threads and tightening the pedal securely. If the creaking persists, consider having a professional inspect and potentially replace the pedal.


How do I fix TPS pedal position sensor A circuit low input?

How do i fix the TPS pedal position sensor in a grand prix pontiac 2004.


Why are my Honda Del Sol tail lights are staying on all the time?

that happens to me ones and that was because the pedal of the brake has a litle rover piece that push a switch, i replace it and that fix the problem!


How can you construct 153 degree angle?

Use a protractor. There is no easy fix. Use a protractor. There is no easy fix. Use a protractor. There is no easy fix. Use a protractor. There is no easy fix.


Why is my bike pedal stuck and how can I fix it?

Your bike pedal may be stuck due to a variety of reasons such as dirt, rust, or a loose crank arm. To fix it, try cleaning and lubricating the pedal threads, tightening the pedal securely, or seeking professional help if needed.


How can I fix bike pedals that are spinning freely?

To fix bike pedals that are spinning freely, you can try tightening the pedal axle with a pedal wrench or replacing the bearings inside the pedal. If these steps don't work, you may need to replace the entire pedal assembly.


How do you fix your brake lights in a 94 blazer that are always on?

Under the dash where the brake pedal rests there should be a switch that the pedal hits when it is released, push it in with your hand, if the lights go out then it needs to be adjusted out toward the pedal by loosening the jam nuts on either side and threading them back. If the lights dont go out then that switch will need to be replaced.