answersLogoWhite

0

What else can I help you with?

Related Questions

My 2002 Polaris Genesis has a problem It displays reverse on the display monitor and there is very little power going to the motor Reverse does not work and there is a light flashing Whats wrong?

I have a 2002 Genesis I and I have to hit the reverse button a couple times to get it into gear. If the light is flashing it is on in reverse that is why you don't have power i n reverse


Why would my Oldsmobile silhouette van not reverse when it is in reverse and i pressed gas pedal?

Becuase you did not put your mini-van in reverse?!


Is a oil plug for a 2000 Oldsmobile alero reverse threads?

no


What is a reverse overlap grip used for in golf?

Putting


What are the release dates for Putting the River in Reverse - 2006?

Putting the River in Reverse - 2006 was released on: USA: 6 April 2006 (Full Frame Documentary Film Festival)


What actors and actresses appeared in Putting the River in Reverse - 2006?

The cast of Putting the River in Reverse - 2006 includes: Elvis Costello as himself Joe Henry as himself Allen Toussaint as himself


How do you change a starter on a 1989 Oldsmobile Regency 98?

disconect the battery jack up car take converter shield off 5 bolts then lossen 2 bolt holding starter diconect wires note them then reverse putting back in but note if there is shims


Where is the high beam switch in 1993 Oldsmobile ninety eight?

on the reverse of the turn signal switch arm


Why does 93 Oldsmobile Cutlass make loud moaning noise in reverse only and you can feel vibration in steering wheel but it stops when brakes are slightly applied?

When a 1993 Oldsmobile Cutlass makes a loud, moaning noise in reverse it is possible that the reverse gear in the transmission is getting ready to go out. The braking system should be looked at too, because of the vibration.


How do you change the back 3 spark plugs on 1999 Oldsmobile Silhouette?

One of two ways from underneath the car or by taking out the front motor mount bolt putting the car in reverse backing up a pinch to rock the motor forward, this should give just enough clearance to get to the back three.


How do you remove 1999 Oldsmobile eighty eight headlight?

To remove the headlight from a 1999 Oldsmobile Eighty Eight, first, open the hood and locate the headlight assembly. Disconnect the electrical connector by pressing the tab and pulling it out. Next, remove the retaining screws or clips securing the headlight assembly to the vehicle, then gently pull the assembly forward to detach it from the vehicle. Finally, replace the bulb if needed and reinstall the assembly in reverse order.


Why does the check engine light come on after putting car in drive and reverse several times?

You have to get the engine looked at.