the reason a speaker blows when you turn it up too loud is because the coil gets hotter and hotter when the cone moves a lot. it will eventually get so hot that the coil will start to smoke then crackle and then stop working.
Chat with our AI personalities
Speaker 3
the speaker sits in the middle
Speaker 1 - APEX
speaker of house.
Speaker of the House
i wanna know if you can really blow a car speaker i wanna know if you can really blow a car speaker
Depending on the speaker it may not be possible or may blow out very early. Check your speaker's rating beforehand.
ocarina
Using a 3000 watt amp with a 300 watt speaker can potentially damage the speaker due to overpowering it. The excessive power can cause the speaker to blow out or distort the sound quality. It's important to match the power ratings of the amp and speaker to prevent damage.
In laymen 's terms, yes. But the "Watts" of a speaker is not what the total power of the speaker is. The are usually two different ratings for speakers to determine the total power. One is "RMS", which means root-means square. And the terms "peak or continuose power". A speaker can be 400 Watts, 360 RMS, 390 continuous power. That means it will take an amp at least 400 Watts to drive the speaker properly. And the speaker will perform at 360 Watts RMS, and peak out at 380 Watts continuous power. Remember, u can't blow a speaker from overpowering it. Only from under power. The speaker will distort and sound horrible from overpowering, but it will not blow.
the car has a radio fuse in the engine fuse box and maybe one in the car but I have never heard of a speaker fuse speaker wires are very low power and there is no need to worry of a power surge as the only travel from the stereo to the speaker and the stereo fuse would blow if too much power went
you are exeeding the factory amp and speaker ratings... its so you dont fry the sterio or blow the speakers
Driving the speaker with too much power is usually the problem. In a surround sound setup, make sure your choose 'small speaker' for the speaker type on your receiver if you are using the B20's as front or center channel speakers. This will offload some of the low frequencies from those channels to the subwoofer.
When you're overpowering a speaker, if you keep the power going, the sound will all the sudden get a lot "fartier", in some cases sounding like you're bouncing a ton of stuff on the speaker. As it gets worse, it starts to sound a little like static, depending on the speaker. At that point it'll get quieter and worse untill you get nothing. Then it's blown.
Of course. You will not get that "in your face" low end sound, and if you crank up the volume, you can blow a speaker out, but if you're sensible about it, it should work fine.
Car speakers can become fuzzy for several reasons, including the speaker being blow. Poor radio reception can also cause them to become fuzzy.
Yes, over time they will not sound as great if you play them loud all the time. They can get worn out just like computer, TV and stereo speakers.