you put a blanket on the trap but not the door open the trap then get back as far as possible.
To remove a drain trap, first, place a bucket underneath to catch any water. Then, use a wrench to loosen the slip nuts on both ends of the trap. Carefully remove the trap and clean out any debris. Finally, reattach the trap by tightening the slip nuts securely.
To remove a sink trap, first place a bucket underneath to catch any water. Loosen the slip nuts on both ends of the trap using a wrench. Carefully remove the trap and clean out any debris. Reattach the trap by tightening the slip nuts. Check for leaks before using the sink again.
To properly remove the lint trap from a Maytag dryer, locate the lint trap door on the top of the dryer. Open the door and pull out the lint trap. Clean the lint off the trap and replace it back into the dryer. Close the lint trap door securely.
To remove a P-trap from a sink, first place a bucket underneath to catch any water. Loosen the slip nuts on both ends of the P-trap using a wrench or pliers. Carefully remove the P-trap and clean out any debris. Replace the P-trap and tighten the slip nuts securely.
To remove the P-trap from a sink, first place a bucket underneath to catch any water. Then, use a wrench to loosen the slip nuts on both ends of the P-trap. Once the nuts are loose, carefully remove the P-trap and clean it out before reattaching it.
If your playing on a laptop with build-in mic, you can blow into it to remove the fire trap
Disconnect and remove p-trap from under fixture. Clean out clog in p-trap and re-install.
I always fling BOTH in the garbage and buy another glue trap.
Suction
Depending on the type of material the trap and waste piping are made of with determine how it is replaced
To effectively remove a P-trap from a sink or drain, follow these steps: Place a bucket underneath the P-trap to catch any water or debris. Use a wrench to loosen the slip nuts on both ends of the P-trap. Carefully remove the P-trap and clean out any debris or buildup. Inspect the P-trap for any damage and replace if necessary. Reattach the P-trap by tightening the slip nuts securely. Run water to check for any leaks and make sure the P-trap is properly installed.
Yes, you can.