If the male and female pronuclei did not fuse during fertilization, zygote formation would not occur, preventing the development of an embryo. This failure of fusion would result in the absence of genetic recombination and the establishment of a diploid cell, which is essential for normal development. Consequently, the fertilized egg would either degenerate or fail to progress further in development, leading to infertility in the affected species.
its lead to the formation of zyzote
The fuse will blow as soon as you turn it on. Use the correct fuse and nothing else.
The device will work, but the 3A fuse will blow quicker than the 5A would have.
Please do not ask such questions that are impossible to solve.
I know what would happen. The three amp fuse would blow. Any device that is plugged into a receptacle with out having sufficient resistance to limit the current flow will dead short the circuit and cause the breaker that feeds the circuit to trip. In this case the fuse being of a lower rating that the feed breaker the fuse will blow without tripping the receptacle's feed breaker.
The TV will over heat and it will end up damaged. It could even cause an electrical fire!!
when the fuse is not working
Intermittant short?
Bulb
If a thick copper wire is used in a fuse then by definition of a fuse this device would no longer be defined as a fuse. A fuse in a circuit is used to protect the conductors feeding the load of that circuit. The circuit, if using a thick copper wire in a fuse, would then be considered as a non fused circuit.
I happen to own one of these. I happen to also have the owners manuel. It is the fuse box located at the passenger side door. Just open the door, and you will see the fuse panel just below the dash. It is next to the hole that feeds the defroster through to the door vents. Open the panel and you will see the fuses. It is #26 and is a large silver fuse. It is a 30 amp.
The blower motor could stop working if it blew the 20 amp fuse. That's probably the worst that would happen. You should replace it with a 30 amp fuse, if that is what's called for in your manual.