answersLogoWhite

0

The record player might be broken. I have on that does the same thing. Maybe the spinny thing is loose in a place or maybe you should just get rid of the record player if it still doesn't work:)

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the problem 1999 Durango turn signal that starts to work then stops?

May be a bad flasher


What fraction of a revolution does the second hand of a clock turn through when it starts at 4 and stops at 7?

3\4


The 45 rpm record was followed by the which in turn was followed by the eight-track tape player.?

The 45 rpm record was followed by the , which in turn was followed by the eight-track tape player.


What fraction of a revolution does the second hand of a clock turn through when it starts at 12 and stops at 9?

three quarters


What a switch does?

What a Switch DoesA switch starts or stops current from passing through in order to turn electrical objects on and off.


Which way does a record player turn?

The turntable turns clockwise.


What fraction of a revolution does the second hand of a clock turn through when it starts at 5 and stops at 12?

if you know the answer put it below if you think it is correct


What fraction of a revolution does the second hand of a clock turn through when it starts at 5 and stops at 11?

Itis (2n+ 1)/2 where n is an integer.


How do you turn an mp3 player off reddmango?

hold the play and pause button until the light stops flashing


Your noise is like the turn signals are going real fast but they are not on and it just starts up for no reason and then it just stops at any time?

Sounds like a short in the wiring.


Your left signal stays on every time you drive it Sometimes it stops blinking and then it starts again What is wrong with your 1996 Grand Marquis?

the turn signal switch in the steering column


What is the pilot setting for a PD15B carburetor on an 1987 Honda xl185s?

turn the pilot screw inuntil it just stops at the seat. Be careful to not over tighten it, it is very delicate and can break. Then turn it out 1 and a half turns. With the engine warmed up turn it in slightly until the engine just stats to sputter, then turn it out until the engine starts to run smooth our turn the pilot screw out from the 1 and a half initial setting until the engine RPM just starts to increase the turn it back in a hair bit to where the RPM just starts to come down.Good Luck