Under ignition coils
2002 Audi quattro 1.8 ignition module location
How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it. How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it.
It appears so, since The Sunroof Doctor has a replacement motor that will fit 1996- 2002 SL models Sunroof Motor 1997-2002 Saturn SC (2 & 3 Door) 1996-2002 Saturn SL (4 Door) Special! New replacement motor available at this price until our stock is gone. You reuse your original connector or hard wire to your harness $81.55
The starter on the 2002 Saturn vue is located on the front underside of the engine, follow the positive(red) cable from the battery and it should connect to the solenoid which is part of the starter.
below left side of instrument panel
The airbag control module in a 2002 Saturn SC2Êis located underneath the center console. It is the yellow connector behind the shifter.
The air bag module on a 2002 Saturn L330 is located under the center floor console. The sensors are also located under the center console.
2002 Audi quattro 1.8 ignition module location
In the front of the motor by the transmission dipstick. This is where your spark plugs from the engine go.
Passlock sensor (Ignition housing) Or body control module fault
It is class 2 short to ground. It is usually caused by a failing ignition switch or body control module.
The ignition module on a 2002 Impala is located in part of the electrical system. In some cars, the module kept the car from starting. When the key was turned there would not be a clicking noise. The module works with the passlock system of the car.
Avalon 2002 air bag module location?
Under coils
It has an engine computer (PCM)
in the dash above the glove box
To replace the ignition module on a 2002 Malibu with a 3.1L V6, first disconnect the negative battery cable to ensure safety. Remove the engine cover if applicable, then locate the ignition module mounted on the front of the engine, usually near the ignition coil. Disconnect the wiring harness and the bolts securing the module, then carefully remove it. Install the new ignition module by reversing the removal steps, ensuring all connections are secure before reconnecting the battery.