answersLogoWhite

0

The eye of a needle.

User Avatar

Wiki User

16y ago

What else can I help you with?

Continue Learning about Art & Architecture

What is an antechamber?

It is a small interior room connected to a door or entrance, leading to a main or larger room.


Where do you find hammer frames in kingdom hearts 2?

Go to Timeless River, from the door to the Cornerstone of Light, as created by Merlin. Chose the door which leads to the building site, andyou will have to face many hammer frames within a certain time limit.


How to remove door panels 2005 dodge ram 150 slt driver door?

Remove the screws form the door panel. One is in the center of the panel, one is at the top front of the door panel behind the mirror and there is 2 small ones at the bottom. Remove the bolt holding the door handle on. Lift the door panel up. It has hooks molded into it on the back that hold it on. Disconnect the wiring plugs from the back. Install is reverse. Very easy to do and no parts to break off. It's easier to reinstall if the window is down.


A car made a dent and a small hole in the backdoor of a 2005 Corolla. Does the whole door have to be replaced or is it fixable And what is a price estimate?

Bring to body shop for estimate


How do you remove cellophane from garage door?

hopefully, the door hasn't been installed yet, but if it has. Dissengauge the garage door opener from the door, ( usually accomplished by pulling the red cord hanging from the operator). the door should move freely by hand. Unplug or cut the power to the opener for safety. You'll need something to stand on to be able to reach the top portion of your door. you'll need a sharp utillity knife. A friend could come in handy also. Lift the door by hand enough so that the top panel of the door tilts inward away from the door openning. It's a small working area but unfortunately all you have. have a friend steady the door in this position or use some vice grips on the door track to wedge the door in this position. Lightly score the left and right edges of cellophane with the knife trying not to cut into the paint and peel away. Hurry with this project, if left to long, the sun may permanently bake the cellophane on your new door. This cellophane should have been removed during the original door install. Check with your door contractor and question why this wasn't done. chances are they'll say to protect the door during construction or painting. All door manufacterers recommend that this film be removed prior to installation. My opinion: make the contractor take it off

Related Questions

What is a small opening in a door or cover?

a hatch is a small opening in a door or cover.


What is small rug by a door?

a door mat


Jaguar Xjs door mirror repair?

If it is loose (within its own housing), try a small Jag specialist. They usually have a few lying around.


How do you remove the front door panel on a 2005 Ford F250?

Use a small screwdriver on the front of the panel that houses the electric door locks and windows to tilt it upwards, then slide it forward to unlatch the back part. There is a small screw now visible that anchors the panel to the door. Use a small screwdriver again on the front of the red reflector to tilt it upwards then slide it forward to unlatch the back tab. Another small screw is now visible that also anchors the panel to the door. Once both screws have been removed, the door panel itself lifts up just over an inch then tilts as there are hooks in the bottom part of the door panel that hold the panel into place within the door assembly. The door panel can now be removed.


Where is the door sensor on a ford 2006?

On a 2006 Ford vehicle, the door sensor is typically located within the door frame or on the door latch itself. It consists of a small switch that activates when the door is closed, signaling the vehicle’s computer system. In some models, it may also be found near the door hinge or integrated into the door lock mechanism. If you're troubleshooting, it's advisable to check the door wiring and connections as well.


Where is the door switch on 2004 xg350 Hyundai?

In the 2004 Hyundai XG350, the door switch is typically located within the door frame, near the latch mechanism. It may be a small button or plunger that activates when the door is closed. If you're having trouble locating it, consult the vehicle's manual for a detailed diagram or instructions specific to your model.


Where is the small access door located in the building?

The small access door is located on the side of the building near the back entrance.


What are the key considerations for pocket door construction?

Key considerations for pocket door construction include ensuring the correct size and type of pocket door frame is installed, proper placement of the door within the wall, adequate support for the door track, and smooth operation of the door within the pocket.


Can you describe the type of door that is in the room?

The door in the room is a wooden door with a brass doorknob and a small peephole.


Why does the Citroen Xsara Picasso boot lock unlock by itself?

There is a small micro switch located within the door of the boot somewhere? if this is faulty it will release the boot by itself. I think it is located either behind the boot door internal panel or behind the exterior boot door handle you press to open.


Why were door knobs really low on the door?

so small people can reach them


Will a front driver side door from a 4 door civic fit in a 2 door civic?

No it is too small.