This is a special job that requires special knowledge and equipment. Some auto body shops can probably do it, but it will cost a good bit if you want it done right.
Oil based paint is best removed with mineral oil or heavy cream like a cold cream. Do not use paint thinner on your skin, it is way too harsh. For latex paint, use soap and water, if the paint is dried use hand cream of baby oil.
The most efficient way to paint latticework - if you can do it - is spray painting, but don't try that if it's already installed in place.
This varies for every car made. One easy way to tell if it is aluminum or not is to use a magnet. Aluminum is not magnetic. Common parts made of aluminum are the radiator, intake manifold, cylinder heads, engine block, transmission case and/or bellhousing, heater core, bumpers, decorative trim, wheels, etc. Not all vehicles are equipped with all or any of these aluminum parts, however.
I strongly recommend you don't paint the slate. If it looks really bad, use Kutz-It (a varnish remover from Home Depot) and 00-grade steel wool to clean it up. Wash it down, and use a marble sealer or even a canuba wax to finish it off. It takes a lot of rubbing to get the slate to be beautiful again. Slate is historic. It adds value to your home, when it is polished, sealed, and with a smooth glow. True Value, a major hardware line, also recommends you do not paint it, because paint has a generally poor adhesion to slate.
The best way to get paint to adhere to stainless steel is to use an etching epoxy primer specifically made for stainless applications. Latex paint and oil-based paint are most commonly used.
The best way to paint aluminum siding for a long-lasting and professional finish is to thoroughly clean the surface, apply a primer specifically designed for metal surfaces, use a high-quality exterior paint, and follow the manufacturer's instructions for proper application and drying times.
Recycle and reuse aluminum
The best way to remove luminated paint from your taillights is by sanding them smooth.
Wheels facing TOWARDS the curb.
paint a picture
The best way to install aluminum siding is to first put in the underlayment. Next, one adds the corner posts, footers, F-channels, and caulk. From here, one can start adding the aluminum siding
put wheels on your case
the best way to get paint off your driveway would be mineral turpentine.
primer coat and then the color you want to paint it.
It is one of the best way to paint your rain boots, if you use water resistant paint.
You can scratch it off but that's not the best way.
The best way to clean an aluminum briefcase from any spots, spills, or stains is by using a damp wash cloth or paper towel that's soaked in water and Ivory soap.