0
Does the code permit bare incandescent lamps to be installed in porcelain keyless or porcelain pull-chain lampholders?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
approximately, whats the cost on a Invitro fertilization procedure?
1. Open the switch housing of the fan. This is usually achieved either by removing two screws on the bottom cap of the switch housing, or three screws on the side. Remove the pullchain assembly by unscrewing the brass finial on the outside of the switch housing. 2. Make careful note of which wires attach where to the pullchain. The chain itself will be marked L-1-2-3 or A-B-C-D or similar, the wires will customarily be of different colors, but if not, mark both the wires and pullchain if necessary. MAKE CAREFUL NOTE OF WHICH WIRES ATTACH WHERE. Every fan is different and if you do not make note there will likely be a complicated guessing game. I cannot stress this step enough. Make careful note of which wires attach where to the pullchain. For example: Black - L, Grey - 1, Brown - 2, Purple - 3. Some fans may use only two or three wires, some may have a pullchain with two layers and five or more wires. Regardless, make careful note of which wires attach where. 3. Remove the wires from the pullchain. In so
Why wont your downstairs light switch work when its turned off by upstairs switch?
It's because they are not wired in a 3-way fashion. The switch downstairs is wired in series with the switch upstairs in the same manner the pullchain on a light socket adapter would turn on and off your light only when the wall's switch is on.
Why does a fan only work on high?
More information would be needed to diagnose your problem more accurately, but here are some tips to start: 1) Fans will not work with dimmers. If you have a dimmer controlling your fan, it will only work when the dimmer in is the full intensity position (if at all). You will need to replace the dimmer with a fan speed control. If one switch controls both the fan and the light, this will not solve your problem, as a light will not work with a fan speed control switch. You will have to settle with a standard single pole switch, a remote switch, or get one more wire between the switch and the fan. 2) If you have a fan speed control switch, but the fan doesn't seem to respond as it should, you may want to pull on the pullchain directly on the fan. If the pullchain is not set to high, your speed control will not work correctly. 3) If #2 or #3 don't apply to you, and you are simply using the pull chain on the fan, you may have a bad switch inside the fan housing, loose or disconnected wires to the fan (unlikely), or simply a bad fan motor.
