0
A type of metric symbol, inlet/outlet
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is a pipe spool drawing?
A pipe spool drawing is a drawing made specifically for plumbers. It is a drawing that helps them to see the intricate network of the pipes so that they can better fix them.
What type of document is used for pipe shop assembly?
Detail drawing
What kind of pipe General Douglas MacArthur smoke?
A Corncob pipe.
How can I stop steam radiator from banging?
It depends on the type of system you have. 1 pipe in, or 1 pipe in and 1 pipe out. Single pipe in/out, try replacing the relief valve or simply shimming the end of the radiator opposite where the pipe comes in. This lets water bleed out of the radiator and stops the klanging.
How do you put a straight pipe on a dirt bike?
cutt off the muffler, the big oval thing near the end of the pipe then buy a metal pipe and cut to the right length if needed. then weld it onto the pipe that is cut
What is a CMP culvert?
Corrugate Metal Pipe Culvert.
What is hume pipe culvert?
Hume pipe Culvert is a cross drainage work or small bridge used to pass flood water through one or number of Precast RCC Hume pipes laid soil.
Where is the soffit of a pipe?
The soffit of a pipe refers to the underside or bottom of the pipe. It is the part of the pipe that is facing downwards or towards the ground. The soffit can be important for ventilation and drainage purposes, and it is often covered with a soffit vent to allow air to flow through.
What is a rectangular hollow section?
Rectangular Hollow Section Pipe means that shape of cross-section of RHS pipe is not round or circle but rectangular or oblong.
How many inch meter is present in a single pipe?
The answer depends on the cross section of the pipe and its length.
What is the invert level of a culvert?
it is the elevation at the bottom of the inside of a pipe (as if there was a drop of water sitting at the bottom) which typically dumps out of a culvert, or spillway
What is obvert in drainage?
The top inside level of a pipe, culvert etc.
What is the volume of 12 pipe?
Volume = cross-section area*length
How many gallons of water will you need to fill 5221 feet of pipe?
It will depend on the area of cross-section of the pipe.
What is the definition of spring line pipe?
If you are asking what is the spring line of a pipe, it is the point of greatest horizontal dimension when looking at an end cross section of a pipe.
What is box culvert?
Box culvert can be described as either a precast concrete or reinforced concrete structure in rectangular figure, facilitating water flow through an embankment of road,etc,as a similar function performed by concrete pipe culvert.
What is another word for drains?
(noun) conduit, culvert, duct, outlet, pipe, watercourse
