I doubt very much that the fender is the same as the darts.
yes you should be able to make it fit.
yes but it may take a few mods. steering may be an issue
only way to tell is measure the length of it from inside hub to inside hub and measure the spring perches as to how far in on the axle that they are welded.
no 73 fenders are different you can use 68 or 69 fenders but there is a small difference in 67 there was no park light is 68 there was a round one up near the body line and in 69 there was a light near the front bottom that was the only difference to use a 68 or 69 fender all you have to do is fill in the light holes I had a 1969 Dart (2 DR HT) and replaced the left front fender with one from a 1967 (?, 2 DR GT). Besides the side light mentioned, the front surface where the headlight brackets attach was further forward. I beat the surface back with a sledgehammer and drilled holes for my headlight brackets. With the front bezel on it looked fine and the external sheet metal was the same. 73, No. 67-72 are the same as far as mounting. But 70+ had a different front end.
No
With different fender contours it would not be an exact fit
An equivalent Dodge Dart should be a compatible fit
yes you should be able to make it fit.
A comparable Dodge Dart, Plymouth Valiant or Duster would work
possible but I doubt it.
I doubt it very much. 2 door cars will fit both Plymouth and dodge 2 doors the 4- door will not fit a 2 door it is a taller winsheild
1967 - 76 all will fit if you change the whole front clip
no.
my friend put a 440 in his.
Yes, 1967, 1968 and 1969 barracudas have the same dashpad, algo you could get a 1968-1969 dart GTS (only GTS) and also fit your application. Reference: Me (1969 barracuda owner) No a 1968 barracuda/dart dash pad is different then a 67 or 69.
Yes
For a 1974 Dodge Dart Swinger, disc brake spindles from 1973-1976 A-body models (like the Dart, Valiant, and Duster) will typically fit. When it comes to front fenders, 1973-1976 Dodge Dart fenders are interchangeable with the 1974 model. Be sure to check for specific details like trim and mounting points, as there can be minor variations.