There should be a positive post under a red shield in the engine compartment. Connect the positive side first on the vehicle to be jumped, then connect the negative side cable to a good unpainted bolt on the engine or one supplied on the body near the positive jump point. Then connect the other end of positive to a good battery of higher capacity than what your car has. Last connect the other end of the negative side cable to a good unpainted bolt on the engine or one supplied on the body. Start the engine on the good car battery and let run for 5-10min. to charge the low battery as much as possible, then start the car to be jumped.
The battery post positive terminal is where you connect the positive cable. Connect the negative cable to anyplace on the engine or chassis. Connect positive first and remove it last.
The most common cause for a Mercedes-Benz not to start is a dead battery. Try charging the battery to see the automobile will start.
Mercedes MG Mercury Mitsubishi
Jump it, it will either start or it wont
When you jump start, at first there is only a little charge, and that charge has to go to all electronic features in your car, like the lights, radio, dash
"w215"
Jump start connections are on the inner front wing.
Where are the jump start terminals under the hood on a 2003 e320
With booster cables
trunk is the battery
If it is automatic - no option but to jump start If it is manual - get someone to help you push the car, engage gear 2 and it should start.
i got a 2007 mercedes benz e350, battery is dead and i need jump started but i can't open the trunk and get do it from the battery, is any other way to jumped?
Waiting for the answer.
This car should never need a jump. Just turn the car off for a few hours and then restart it again. It should charge up enough during this time to start again.
You just jump start it.
how to jump start 2009 impla
To jump start a 1997 Mercedes 500SL, first ensure both vehicles are turned off. Connect the red jumper cable to the positive terminal of the dead battery and the other end to the positive terminal of the working battery. Then, connect the black jumper cable to the negative terminal of the working battery and attach the other end to a grounded metal surface on the dead vehicle, away from the battery. Start the working vehicle, let it run for a few minutes, and then attempt to start the 500SL.