2JZ-GE Engine # Disconnect the negative battery cable. Wait at least 90 seconds before performing any other work. # Remove the engine undercover. # Turn the drive belt tensioner clockwise and remove the drive belt from the engine. # Disconnect the generator electrical connector. # Remove the rubber cap and nut and then disconnect the alternator wire. # Disconnect the alternator wire clamp from the wire clip on the alternator. # Disconnect the A/T coolant hoses and bracket from the alternator by removing the bolt and pipe clamp. # Remove the alternator bolt, nut, pipe bracket and then remove the alternator from the engine. To install: # Install the alternator and pipe bracket. Torque the bolt and nut to 27 ft. lbs. (37 Nm). # Install the A/T oil cooler pipes to the alternator and install the bolt and pipe clamp. # Connect the alternator wire clamp to the wire clip on the alternator. # Connect the electrical wire to the alternator and install the nut. # Install the alternator electrical connector. # Install the drive belt. # Install the lower engine cover. # Connect the negative battery cable. # Start the engine and check the charging system for proper operation
Lexus, Land Rover if you mean brand. Lancer if you mean model.
If its a 94-96 Model it`s under the seat !
Check to see if power is getting to the starter. If it is not check the solenoid contacts in it may be burned and not letting the power threw . If power is making it to the starter it maybe your brushes are in need of replacement or (dirt in starter ,broken magnets ,bearings or burnt wires).
On that car it is called a transmission range sensor and it attaches transmission gear selector cable to transmission. Just remove and install new part in reverse order (if that is the problem).
Which model is it, year etc. on a 95 pug 306 XL 1.4 its quite difficult to get at ( im trying to change mine now) if you look at the rocker cover (top of the engine) its towards the cockpit at the back of the engine on the right. an easier way to find it is to follow the leads off of the battery one should go behind the engine and to the starter
The starter for this model is located on the driver's side, at the front of the engine.
My wife's LS400 has the upgraded $4500 Nakamichi Sound System which was the best they offered. I do not know what the standard model was or if there was an in between model to choose from. Hope this helps.
The Lexus ES300 and LS400 have different engine configurations and specifications, which means their parts are generally not compatible. The ES300 typically features a V6 engine, while the LS400 is equipped with a V8 engine. As a result, components such as the engine block, cylinder heads, and many other parts are specific to each model. Always consult with a professional or refer to specific part numbers for compatibility.
The antenna on the Lexus LS400 connects to the radio receiver and is responsible for capturing radio signals for AM and FM broadcasts. It is typically mounted on the roof or rear of the vehicle to optimize signal reception. Additionally, the antenna may also be involved in satellite radio or navigation systems, depending on the specific model and features of the vehicle.
how do i change front interior light for lexus rx 300 2004 model
To change the thermostat in this Lexus model, follow the upper radiator hose to the aluminum housing--the thermostat is located in that housing.
To remove the headrest on a Lexus LS400, first, locate the release buttons or levers on the sides of the headrest posts. Press these buttons while simultaneously pulling the headrest upward to detach it from the seat. If there are no visible buttons, you may need to use a small tool to press a hidden release mechanism. Always consult your vehicle's manual for specific instructions related to your model year.
how do i change the oil mainance warning light on lexus rx330 2005 year model
In a Lexus LS400, the fuse responsible for the trunk and gas door release is typically located in the fuse box under the dashboard. Specifically, it's usually labeled as "TRUNK" or "FUEL" in the fuse diagram. It's important to consult the owner's manual for the exact location and specifications, as there can be variations depending on the model year. If the fuse is blown, replacing it should restore functionality to both the trunk and gas door.
How do I replace the starter on my polaris 250 4x4 Model number is EC250PF00802151. How do I change the stater on a 99 polaris explorer 4x4
When my battery kept dying on mines I have the same make and model. First I kept getting it recharged it still kept dying then I got someone to look at it and it was my alternator when I replaced that it did just fine.
Lexus LFA