answersLogoWhite

0

There should be a jack and rods under the rear seat. Look closely at the rods, one of them should fit the cranking mechanism to the upper right of your license plate. Turn it counter clockwise to lower it and clockwise to raise it.

User Avatar

Wiki User

10y ago

What else can I help you with?

Continue Learning about Art & Architecture

How do you replace a starter on a Mazda B4000 pick up truck?

This truck uses three different engines, all with slightly different starter mounting. All starter replacements are pretty similar though. Most importantly you must first disconnect the negative battery cable. Raise and support the vehicle. From under the vehicle remove the large and small power wires to the starter. Remove the starter mounting bolts Remove the starter. Reverse procedure for installation.


What was the last production car to have a carburetor?

The Last production car with a carb. was the 1990 GM 307 cid used in mostly all GM wagons. The last production truck with a carb was the 1993 Isuzu pick up. The answers apply to vehicles built for the USA.


How does one replace a starter on a 1991 Toyota pick up truck?

if its a v-6 remove the RF tire, remove the 4 10mm bolts on the inner fender shield and the clips that secure the rubber shield. this will give you enough clearance to remove the starter. remove the front splash shield and you can see the starter on the passenger side of the engine. remove the small wire, remove the large wire with a 12mm socket on a long enough extension to reach it from the bottom of the veh. The rest is acedemic, a couple of bolts and a little twisting of the starter it will come out right through the wheel well.


How do you get a rear axle out of a 2002 Chevrolet 1500 2wd pick up truck?

It would be best to consult the Factory Service Manual. Remove from the axle: tires, drive shaft, shock absorbers, parking brake cable and the soft brake hose. Remove the u-bolts and lower the axle.


Where is fuel filter located on 2005 Toyota sequoia?

I may be wrong but I know most pick ups hav a fuel pump/sending unit located on top of the fuel tank it is usually sold as a set I worked at an auto salvage and when people called the would ask for a fule pump and it would come with the sending unit. You have to drop the gas tank to get to it.

Related Questions

Where is the knock sensor for Toyota Pick up truck 1989 3.0 V6 3VZE located?

under the lower intake manifold


What is a Hilux?

The Toyota Hilux is a pick up truck


Oil for a 1990 Toyota pick up truck?

5w30 or 10w30


Will a Toyota 20R fit into a 87 pick-up truck 4x4?

Yes!


Is a Toyota Tacoma a van a car or a jeep?

The Toyota Tacoma is a compact pick up truck.It is not only a truck but it is a great truck. The Tacoma was announced as Motor Trend Magazine's Truck of the Year for 2005.


How do you adjust the clutch on a 1989 Toyota pick up truck?

there is a joint AT THE BOTTOM OF THE CLUTCH AND A BOLT U TIGHTEN THAT AND U ARE DONE I DID IT TO MY TRUCK


What type of transmission fluid does your truck take?

What type of transmission fluid does my 1989 toyota pick up truck take, manual 4 speed.


How do you make my 1986 Toyota Corolla sr5 run faster?

take out spare tire and replace with a can of fik a flat you can pick up at Walmart


What is the best valve clearance for 1989 22RE Toyota pick up truck with a 180k miles on it?

006 to 008


Where is the rollover fuel pump shut off switch located on a 93 Toyota pick up truck?

it does not have one.


What's the average lifespan of a used Toyota pick-up truck?

While the age depends on how well the truck has been maintained, Toyota trucks can often go for 250,000 miles before needing a new engine.


What are some cheap but reliable pickup truck models?

Chevrolet is a cheaper pick up truck than Ford and very reliable. Toyota is another cheaper but smaller truck. So it depends on how big of a truck you need