answersLogoWhite

0

It sounds like your carbs are set wrong. You need to adjust your air fuel mixture screw on the bottom of the carbs by the bowl. You won't need to take the bowl off to get to the adjustment screw. Turn the screw all the way in til lightly seated then then count the turns out. Set both carbs at 2 turns out. When it bogs down pull the choke and if it runs better then you are not getting enough fuel. If it gets worse then it is getting to much fuel.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Why is my 1978 Yamaha 250 bogging out and backfiring?

it is either your fuel lines arnt hooked up to the carbarator right or your fuel lines a clogged and it is starving for gas


Does a 250 Yamaha beartracker have an oil filter?

yes it has an internal oil filter


Your Yamaha ttr-90 will stall when put into gear?

My sons did the same thing until I cleaned the carb out and adjusted it properly.


What is internal parts of Yamaha Rx 135 motorcycles engine?

enging spere parts


I cleaned my carburetor for my Yamaha bruin 350 now when you give the gas it stalls.It will idle. what did I do wrong?

If the carburetor is cleaned on the Yamaha Bruin 350 and it will idle but stall when given gas, it could be that the float is sticking. The carburetor may also need to be adjusted by turning the adjustment screw so that it is not getting too much gas when revved.


Why won't my Yamaha yzf 600 idle?

Make sure you have coolant. Get your carbs synced and cleaned. Those things fixed my problems. Good Luck.


Why does Yamaha blaster stops after ten minutes?

I had the same problem it run 5 min then stops... i cleaned my carburator twice and now its runs great :)


Yamaha Blaster trouble please help ASAP i have a blaster and when i gicve it half throtle it bog and jumps and i already cleaned the carb what is wrong?

check your reeds


What could be causing the Yamaha digital piano sound problem?

The Yamaha digital piano sound problem could be caused by issues with the internal electronics, speaker malfunction, or problems with the audio output connections.


How Do you replace the internal battery on a Yamaha AW16G Multitrack Recorder?

To replace the internal battery on a Yamaha AW16G Multitrack Recorder, first, disconnect the power supply and remove the cover to access the internal components. Locate the battery, which is typically a CR2032 coin cell, and carefully unscrew or unclip it from its holder. Replace it with a new battery, ensuring the polarity is correct, then reassemble the unit and reconnect the power. Be cautious to avoid any static discharge while handling internal components.


Why does my 2001 Yamaha Rapt or 660 keep bogging down once you give it Gas it will Work for a little bit and then start to backfire and bog down again?

you need to put a jet kit in it if it has any performance parts like an aftermarket pipe or a k&n air filter with a modiffied air box.


1992 Yamaha blaster no spark is it a cdi box?

Mine had a bad sator. Spray some brake cleaned in side the flywheel and see if it fires. Mine fired right up. Replaced the stator