answersLogoWhite

0

The positive battery cable connects directly to the starter. Depending on what type of vehicle it is, the solenoid is either on the starter or on the inner fender. Power for the solenoid comes from the ignition switch. You can run a wire to the solenoid to cause the starter to engage.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Why is the starter not grounding out?

3 reasons either the starter is not getting power from the solenoid, solenoid is not getting power from the battery or starter is burned up.


Where does a starter solenoid get power from on a 1997 Chevy s10?

the starter relay.


How do you check to see that the starter is the problem?

Remove starter and bench test See if you are getting power to starter


Would a starter drain power out of a battery?

Yes, but only when you have the starter engaged


Will your car lose power if the starter goes out?

no, the starter is only for starting the engine.


How do you replace a starter?

disconnect power from battery, remove wires connected to starter, remove bolts from starter (usually 2), remove starter.


Why won't a 1989 Nissan starter spin?

Blown fuse, bad starter, bad wires to the starter, no power.


What is the purpose of a starter relay on a motorcycle?

Which connects starter motor and the battery temporary to get sufficient power to starter motor.


What would cause a power wire to burn from the starter to the battery?

why would my starter wire burn, going from starter to battery


Why does my car Have power but starter makes no noise?

Dirty or loose connections or a bad starter.


What does the S mean on a starter?

Putting 12V power to that "S" post will ingauge the starter.


Is there a common cause for a 1987 454 ltd not to crank when the start button in pressed?

Start by checking battery voltage and then use a test light to check for power at the starter when the button is pressed. If you have power at the starter with the button pressed it could be a bad starter. If no power at the starter then check into wiring and/or relays.