answersLogoWhite

0

Creating an Omnitrix is no easy task, but I shall try to explain it as simply as I can. =You Will Need= * Bisynthium Alloy (about a kilogram) * Sand * Glass furnace * Twenty LED lights * Artificially stabilized stem cells * At least ten extraterrestrial DNA samples of your choice * 14Ci Galven SMP radiation (stabilized) * Galvanic particle fusion chamber * One IPM * A hot cup of tea * Soldering iron =Method= # Prepare a small glass "face" for the Omnitrix using methods found in "how to make glass." Put this aside for later # Now we need to make the body of the watch. Start by shaping your Bisynthium alloy into two hollowed out watch shapes for fixing together around the circuitry of the Omnitrix # Place a hot cup of tea into the IPM and enter the probability code "100, 784, 108, 793, 378, 388/100,400,908" # You should note that a lot of circuit boards and wires should have materialized right behind you, along with a rubber duck. You may discard the rubber duck # Attach the purple end of the blue wire to the north of the SMP radiation source # Attach the yellow end of the green wire to the south of the radiation source # Connect the orange end of the blue-with-purple-stripes wire to the non-magnetic part of the radiation source # Now, solder the ends of all wires to Circuit Sector 12 in the shape of a pentagram (but make sure not to get it upside-down or a giant red person will crash through your house) # Fit all of this to the inside of the watch's body # Screw both halves of the watch together # Place the LED lights atop the watch face # Smear your stabilized stem cells onto the glass plate # Attach the glass plate # Place the extraterrestrial DNA on top of the watch then place it inside the particle fusion chamber at gas-mark 10,000 for twenty minutes # Remove Congratulations, you have just created your own, fully-functioning Omnitrix. Alternatively, you could paint some cardboard tubes and glue them together.

User Avatar

Wiki User

16y ago

What else can I help you with?