Just put a switch in the power wire going to the coil.
no
Find the fuse for it and pull it.
I don't think your car has one.
If you have an alarm on your car, make sure there isn't a kill switch on it.
Myself, I do away with all the starter switches since I own six Samurai's and want more. I have a floor switch that is in a lock combo vault that kills the engine, and is in a stainless steel tube under the bucket so no one else can start it less they know the combination. Then I go to a start switch and turning that on and hitting the button starts my jeeps. Turning off the start switch kills the engine while the security switch is between the shifters in the lock combination box. This is not the only security there is a weight switch in the driver seat that you have to weigh as much as I do or it won't start, and two other dead switches you need to know where they are before the jeep will start. In the mean time, your kill wire is broken under your dash somewhere. Each time you put a new starter on it, and plug it into the wire harness you still have not fixed the kill wire on the other side of the plug. Want more help on questions go to www.SuzukiSamuraiParts.com or www.Samurai4x4Club.org With an 87 you have round vents the center dead spot all you need to do is put in a key kill switch that leads to your battery, then when you want to turn off the jeep kill it by the turning off the kill switch and leave the key in or take it out. Mounting it, you should use a large washer to cover that blank vent area and then another behind it so that you can screw the kill switch through it securely. Myself, I just don't like keys! And the fact that having six Samurai jeeps trying to figure out what key goes to what jeep is hard enough, but to have a kill switch located on the dash center area, when four wheeling, and you NEED to kill the jeep its really hard to reach down and turn the key off, just hit the rocker cover over the switch and the jeep is shut off faster and safer then turning the key off. For me, and all my girlfriends that drive the other jeeps its quick to start and shut off.
There is NO TYPE of kill switch on that truck what so ever.
There is no "kill switch" on that Chevy Blazer.
The 1999 Chevy Cavalier does not come with a factory-installed kill switch. However, some owners may have added aftermarket kill switches for security purposes. If you're concerned about theft or want to install one, consider consulting a professional for proper installation.
NO, They were not used on chevy trucks.
I have a 93 chevy pick up all I want is to hard wire the starter so the the truck will start with just wire straight from the starter to battery
It does not have one.
No.
no such thing on GM
GM vehicles are not equipped with a fuel pump inertia switch.
No where. It doesn't exist until you install one.
FOrd Explorer 2008 comes equipped with Kill switch that you activate through menu in dash.
If you mean an inertia kill switch for the fuel pump, no.