answersLogoWhite

0

You don't. Cheap metals not designed for heat should not be used for branding. Soldering kits do not work either. Check out BME online to network with people who can give you more information about safe branding. The supplies are not overly expensive and doing it the right way creates a better brand that is well worth the research and expense of doing it safely. Good luck.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How can a person make their own wreath hanger?

One can make their own wreath hanger by using some magnets to hang it up. One could also use a wire hanger and cut it to create a hook to hang the wreath.


How do you get your wedding ring from under the dryer?

try a wire hanger use a flash light to see were it is at then use the wire hanger to get it out


How do you break into an Oldsmobile cutlass?

With a wire hanger


How can I fish a wire through a wall effectively?

To fish a wire through a wall effectively, you can use a fish tape or a wire coat hanger to guide the wire through the wall's openings or cavities. Start by creating a small hole in the wall near the starting point and use the fish tape or coat hanger to push or pull the wire through to the desired location. Make sure to secure the wire to the fish tape or coat hanger securely to prevent it from getting stuck inside the wall.


How can I fish wire through a wall effectively?

To fish wire through a wall effectively, you can use a fish tape or a wire coat hanger to guide the wire through the wall cavity. Start by creating a small hole in the wall near the starting point and then use the fish tape or coat hanger to push or pull the wire through the wall to the desired location. Make sure to secure the wire to the fish tape or coat hanger securely to prevent it from getting stuck inside the wall.


How do you make a homemade bait net?

Makeing a home made bait net. WHAT YOU WILL NEED, A big onion bag you can get one at fruit and veg shop. A stick about 6 ft long. A clothes hanger . (wire one) Treid the top of the bag around the hanger. And using tap or nail's secure wire clothes hanger to top of stick. And there you go a homemade net.


Where do you get halo writing?

A bent-to-shape wire hanger usually does the job


Key stuck in door on driver side any suggestions?

get a wire hanger!


How to you cut a hanger?

Assuming you have a standard wire coat hanger, you can either use a hacksaw or a pair of sturdy side-cutting pliers. Some ordinary pliers have little recesses near the jaw that can also be used but they tend not to make clean cuts.


How do you unlock a 1998 Plymouth Voyager with a hangar?

You can't....a hangar is where you keep and airplane. But if you had a wire hanger, you would be able to untwist the wire hanger and then proceed to attempt to unlock the car -- but I think your best bet is to call AAA or a locksmith.


How to unlock a 2008 Chevy Cobalt door without a key?

Wire coat hanger


What is the most reputable brand of speaker wire?

Monster Wire is a very good, reputable brand of speaker wire.