If they are new ones, I paint them outside in full lengths before i cut and fit them. If painting existing ones in situ, I do them with a 1.5 inch sash brush and a thin metal edge slid under on the carpet side.I have a thin steel strip that works for this. Got it in a decorating suppliers.
I paint all baseboard outside on saw horses, before I even cut it to fit. If I took old base board off, I would still do this.
You paint walls first and skirting and baseboard are best painted after or even outside if it's good weather.
I always try to find a spray enamel as close as possible to moulding.
As long as you are using a similar type of paint (I expect it is an indoor latex, since baseboards are found indoors) and as long as the existing paint is still in good condition and is not flaking off, then yes, you can paint right over the existing paint. If the paint is in bad condition, you should remove it before repainting.
You can calculate the amount of paint needed by finding the square footage of the room to be painted. Each manufacturer has a recommendation as to how many square feet a gallon of paint will cover. Make sure to calculate for primer if needed and or a second coat of finish.
That is up to you. The more gloss a paint has in it, the easier it is to clean and the more abuse it can take. For the most part, ceilings are only flat.
No, it never sticks on.
You paint walls first and skirting and baseboard are best painted after or even outside if it's good weather.
Use whatever sealer is recommended for the paint or stain that your going to use to finish with. Just be sure to seal the baseboard on all surfaces, front, back, top and bottom
I always try to find a spray enamel as close as possible to moulding.
I am not sure how much detail you will need. Are you asking about painting a wall with a brush and roller?? For starters, I figure how much paint will be needed and buy the paint. Get out your tools and drop cloth(s) and prepare the area so you will have enough room to work. Remove picture hangers and switchplates. Spackle the holes, let that dry and sand where appropriate (for pin holes just use your finger to apply the spackling, no sanding necessary). If you sand on a textured wall, you make have to repair the texture, so this would be done before painting too. I will put a piece of tape over the baseboard to prevent drips and paint from landing on it. Cut the edges and corners with a brush and then roll the paint on the rest of the wall with your paint roller. Remove the tape from the baseboard and then cut your line from the wall to the baseboard while the rest of the paint is still wet. Does this answer your question??
As long as you are using a similar type of paint (I expect it is an indoor latex, since baseboards are found indoors) and as long as the existing paint is still in good condition and is not flaking off, then yes, you can paint right over the existing paint. If the paint is in bad condition, you should remove it before repainting.
A baseboard can be 3/4 inches
I charge 30 per hour for that. Obviously costs differ according to local market .
You can calculate the amount of paint needed by finding the square footage of the room to be painted. Each manufacturer has a recommendation as to how many square feet a gallon of paint will cover. Make sure to calculate for primer if needed and or a second coat of finish.
That is up to you. The more gloss a paint has in it, the easier it is to clean and the more abuse it can take. For the most part, ceilings are only flat.
the baseboard is called 'une plinthe' (fem.) in French.
Yes, electric baseboard heaters can be painted.