Be sure the hole are free of contamination, oils, and dust. The affected area is best to be a rough texture to allow for bonding. Patch the affected area with a stainable polymer modified patching material or you can use gray portland cement with some sand aggregate. If using the polymer patch option, be sure to apply TWO coats (one filler and one finish). If you decide to use the portland mix, scrub some re-emulsifiable bonding agent into the hole before you fill in the patch, allowing it to dry ONCE.Be sure the patch is completely dry and cured before you stain otherwise the patch may turn out darker than the rest of the floor.
First of all, you have to clean them really well before painting. Some people even remove the doors and hardware first, filling in the holes left by the old screws. You will have to prepare the surface first. Sand, seal or both. The danger is having the paint peel off if the cabinet is bumped or scratched.
Holes that form by huge blocks of glacier and that have been burrowed into the ground are called kettles. There are many types of holes.
Holes that form by huge blocks of glacier and that have been burrowed into the ground are called kettles. There are many types of holes.
You need to re-bore the existing holes or drill new holes. :) Simplest solution: Use self-threading screws slightly larger than the original screws.
thin material holes can be welded and ground flush, think material can be threaded and plugged. Bondo works, too.
You need to make sure the concrete is clean and free of loose debris. Patch any holes in the concrete (let dry and settle).
With a concrete crack filler
Cement mixed with water, sand (gravel) - in other words more concrete.
Ensure concrete is clean, smooth and dry. Concrete should be first cleaned with degreaser to remove any residue. Use a self leveling compound if floor is not level or has some low areas. Fill any cracks or holes prior to using leveler. Allow leveler to dry overnight and seal concrete the following day to prevent moisture from wicking through concrete. Install flooring of choice.
Clean it, fill any minor holes, then primer it.
A driller, two spotters
No, unless you don't mind patching holes you leave behind.
Gas (air) trapped in the mixture was not removed. The bubbles make the holes.One method to reduce the holes and get a smooth finish when the formwork is removed, is to use a concrete vibrator. This tool is poked into the wet concrete before it sets and vibrates the mix to encourage air to come to the surface. It can be very effective. This also makes the concrete stronger by eliminating weaknesses caused by air pockets.Concrete vibrators must be used carefully and should not be allowed to contact the formwork or reinforcing as they can mark the surface and move the reinforcing. Excessive use can also separate the fines and the coarse aggregate making the concrete weaker.
It is a wall constructed from individual small concrete blocks. It may be steel reinforced or not depending on application. They are quick to erect.
drill holes and insert a concrete lag that follows layout for the door and then attach to the door casing.
stellar black holes were stars (these are large)primordial black holes were pieces of the big bang (these are microscopic)
No, it is not possible to prepare bait for a carpenter bee. A better approach is to spray an insecticide in visible nest holes and wait a few days for it to take effect.