Just use satin finish paint.
No, the color in spray paint is not affected by bleach. A proprietory concrete cleaner or fine sand impregnated with solvent will reduce the appearance of the paint.
reduce mess and keeps everything inside bucket.
I'm guessing this is auto paint. The best rule is to use a reducer of same brand some are not compatible with other brands. e.g.(PPG paint PPG reducer & activator). You will most likely have issues if you mix and match brands. And yes urethane reducer can be used with urethane paint.
Yes you can. Either airless or a cup gun with an air compressor will work. Professionals can use electrostatic spraying equipment to reduce overspray.
The brittleness of the paint. Expensive paint will not break in a good gun, but will when dropped from knee height. Also cost.
Brittleness isn't a material, it's a characteristics.
with more and more paint
Brittleness means the property of snapping easily when a force is applied.
Reference ASTM D746 - 07. This applies to Brittleness testing of elastomers and plastics.
Reference ASTM D746 - 07. This applies to Brittleness testing of elastomers and plastics.
No, oxygen itself cannot exhibit brittleness because it is a gas at normal atmospheric conditions. Brittleness is a mechanical property exhibited by solid materials when subjected to certain stresses.
Yes, brittleness is an intensive property. It describes the tendency of a material to fracture or break without significant deformation under stress, and it does not depend on the amount of material present.
Just use satin finish paint.
Brittleness is not a characteristic of most metals. Metals are usually ductile and malleable, meaning they can be bent and shaped without breaking. However, some metals, such as cast iron, can exhibit brittleness under certain conditions.
Brittleness is considered a physical change. It is a change that can be felt, and interacting with it does nothing to change it into something else.
the hardness of iron decreases with increase in brittleness in general..however when the temp is increased, the elasticity increases and the brittleness reduces, it continues to show the increasing trend in hardness until a transition temperature, after which the hardness starts decreasing again.