remove grill,remove bumper,unbolt fender bracket off bumper bracket,take off splash pan in between door and fender,take out fender bolts,don't forget bolts on bottom of fender.there is a bolt under the fender ,back by the door at the top.pull fender off.good luck.
the answer is the same as the 1967 dodge dart grille i already posted but be carefull the plastic will break
GTS had no grille emblems from the factory, a GTS emblem was on the hood in front in the center of it.
The 2013 Dodge Dart has an inline 4 engine.
The 2014 Dodge Dart has an inline 4 engine.
The 2013 Dodge Dart is a gas-powered vehicle.
I think the 67 grille was a little different.
the answer is the same as the 1967 dodge dart grille i already posted but be carefull the plastic will break
yes
To remove the timing cover from a 1967 Dodge Dart, first ensure the engine is cool and disconnect the battery. Drain the engine oil and remove any accessories that obstruct access, such as the radiator or fan. Loosen and remove the bolts securing the timing cover, and gently pry it away from the engine block. Be cautious of any gaskets and seals that may need replacement during reinstallation.
14" rims came on the 67 GT dart.
yes, all 67's had points from the factory.
It was either the 225 slant 6 or the 273 V8.
I don't believe you have enough fender clearance in the rear.
Production of 1967 Dodge Dart GT convertibles, for the American market : > > 6-cylinder : 1,761 > 8-cylinder : 1,626 > TOTAL : 3,387 Estimated that 10-15% still exist. So maybe around 500 left.
Dodge Dart was created in 1960.
GTS had no grille emblems from the factory, a GTS emblem was on the hood in front in the center of it.
The 2013 Dodge Dart has 16 valves.