They are under the intake manifold.
Yes.
No it denfinately will not
My RV Chevy engine V8 454 has 43000 miles , til now inewer had a problem, my last trip was a horror, after 50miles the engine begin to cought and misfiring on the muffler, and it was not running round
Yes. The vehicle they were installed in (and the options the vehicle had) would dictate the size/capacity of the alternator that was used.
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
Yes it does. Chevy did not use solid lifters in that engine.
can the valves be adjusted on a 1998 454 7.4 vortex with the roller lifters
The standard fuel pressure for a 1998 Chevy 3500 with a 454 engine is 50 PSI. If fuel pressure drops much below this level, the fuel injectors will not work properly.
under the intake manifold.
Any Chevy transmission will bolt to any Chevy engine.
Remove carburator then intake manifold then cylinder heads
250 hp and 530 nm torque The 1998 Chevy 454 had stock HP figure at 290 and torque at 410lb ft.
Were is the temperature heat sensoe on a 454 chevy motor.
what is the ignition timing for a 1988 Chevy 454 engine
remove engine should be pretty straight forward after that
You can't... There's not enough steel in the cylinders to bore it that far. If you want a 454, you need to by a big block 454 Chevy engine.
Unplug the wiring harness from the iac. Using a adjustable or a 1 1/4" wrench remove the iac.