Wheel bolts go through a hole in the hub and are held in place by a knurl toward the head of the bolt. Search napaonline for a picture of one.
To remove just take off the wheel and pound on the stud where the lug nut was. You probably have to spin the wheel until there's a place for the bolt to come out of the back of the hub.
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
THE WATER PUMP ON THE ACCORD IS DRIVEN BY THE TIMING BELT AND YOU WOULD NEED TO REMOVE AND REPLACE THE BELT AT THE SAME TIME AS THE WATER PUMP
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Try moving the steering wheel left and right then attempt to turn the key.
it sounds to be as if your power steering pump is out or low on fluid.
You must remove the wheel/tire in order to remove the front strut.
The 2004 Honda Accord has front wheel drive.
The 2013 Honda Accord has front wheel drive.
The 2002 Honda Accord has front wheel drive.
The 2003 Honda Accord has front wheel drive.
The 2006 Honda Accord has front wheel drive.
The 2011 Honda Accord has front wheel drive.
The 2005 Honda Accord has front wheel drive.
The 2007 Honda Accord has front wheel drive.
The 2009 Honda Accord has front wheel drive.
The 2001 Honda Accord has front wheel drive.
The 2008 Honda Accord has front wheel drive.