Usually even a pretty rough surface can be salvaged by applying a skim coat of joint compound to the surface. First, remove all loose edges of paper and paint etc. Next spot prime exposed paper with an oil based primer and let dry. Then take a 10" or 12" knife and using medium to heavy pressure fill all voids and the surrounding areas with joint compound leaving as little excess on the wall as possible. Let dry and sand flush with existing surface removing ridges. Repeat the last step feathering the joint compound so that once you sand there are no ridges. Finally, texture to match. Sometimes it is just as easy to skim the whole wall for a more conistent surface and you dont have to worry about matching texture. Remember that the heavier the texture, the less detailed your patching will need to be to hide signs of repair.
Sounds like they replaced it with a standard windshield not designed for HUD. HUD windshields are specially designed not to have double reflections from the two glass layers.
The action of water and gravity cause them to form in layers.
Arteries actually have 5 layers, it is the veins that have 3. Arteries have: -the Outer coat -Elastic layer -Middle coat (thin) -Another elastic layer -Endothelium
Some planets are made completely of layers of thick gases. Also space exploration has not progressed enough to a point where the layers of other planets have been discovered.
The three layers of an artery are Endothelium, smooth muscle, and connective tissue.
i suggest layers and layers of cardboard
There are 4 layers in a tetra packaging-Plastic,paper,alluminium & cardboard
You could sandwich layers of cardboard vertically and carve it in the shape of a chair or bench.
Make it with cardboard and news paper place layers of newspaper between 2 layers of cardboard this will hold the heat and keep the water from freezing
A saw would be better - like a band saw
melanin
They usually dig Intel they reach the bottom and then build thier nests.
Syncline.
Anything with lots of air pockets within the material. Soft wood, layers of cardboard, styrofoam of course.
No. Cardboard is a thick paper, possibly in layers, made with ground up fine particle wood material, possibly recycled, held together with glue and possibly other materials to give it desired properties.
The problem with using cardboard as an insulator is that it is too easily damaged in a variety of ways. It tears easily, it can be set on fire relatively easily, it absorbs water very easily and it will disintegrate or become moldy, if it does get wet. So although cardboard is an insulator, it is not durable enough for most purposes that require an insulator.
Try placing a piece of heavy cardboard (corrugated would be best) cut to size over the cracked bottom. Then cover that with several layers of newspaper to keep the cardboard clean since you can't really clean cardboard.