You need an O2 sensor socket or wrench from your auto parts store. Find out if the code is 1 or 2 left or right bank. The 1 is toward the front of viechle 2 towards the rear, bank 1 is drivers side. 2 is pass. side. Located under the viechle on the exaust system. When relplaced you can clear the code by removing the Negative battery cable for 10 min.
my light went off when i put a new gas cap on and unhooked the battery 10 min too reset
The 1999 Chevrolet Suburban speed sensor is located on the back of the transmission. The speed sensor will be in the upper left-hand corner.
Trouble code P0325 means: Knock Sensor 1 Circuit (Bank 1) Trouble code P0330 means: Knock Sensor 2 Circuit (Bank 2) Need to replace Knock sensor
It attaches to throttle plate (next to throttle cable) to cruise control unit.
The vehicle will have two sensors one in each of the exhuast manifolds. Use a special socket available from just about any auto parts store. I realize that a special tool is needed, but what is the process for accessing the sensor?
The speed sensor is on the top back corner of the transmission housing. It is held down by one screw.
You don't, you replace or rebuild the engine.
on my 1999 ford mercury villager its on top of transmission under the van
Unplug the sensor and unscrew it from the exhaust pipe. You'll probably need a special socket to do it without damaging the wires.
1999 - 2002.
Cam position is taken from the distributor, there is no separate sensor near the cams.
I payed $117.00 at auto zone
The oxygen sensors are in the exhaust pipes on most models.
The speed sensor is on the top rear of the transmission. It is held on by one screw.
If you're talking about the sensor for internal temperature it's in the dashboard next to where the shift lever is.
Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.
Cam position is taken from the distributor, there is no external cam sensor.