1. raise the fornt of the vehicle up so that you can lay under the front end. 2. drain the coolant from the radiator. all of it. 3. follow the lower radiator hose form the radiator to the engine. you will see 3 bolts. remove the hose, then take the bolts out and pull the pipe off. 4. remove the thermostat. 5. take the new thermostat, install the new rubber gasket around the edge of the thermostat just like what's on the old one. 6. reverse removal instructions to install 7. pour new coolant into the radiator but do not fill all the way up. start engine, do not put radiator cap on yet, let engine warm until thermsotat opens, about 10 to 15 mins. some coolant will come out of the cap opening, this is normal, the coolant level should drop, fill up with coolant at this time and install the radiator cap. IT'S VERY IMPORTANT TO GET THE AIR OUT OF THE SYSTEM, AS THIS MAY CAUSE IT TO OVERHEAT.
To replace a broken key in a 91 Subaru ignition, you will need to contact a locksmith. The locksmith can cut a key to match your ignition.
The oil filter on the 1998 MPV is on the side of the block. It screws on and is easily replaced.
You may need to replace the speedometer fuse. The speedometer cable can cause your speedometer to stop working. The speed sensor can also cause the speedometer to stop working.
Have vehicle scanned to determine the problem
There was no indication in records of any MPV 4-cylinder, only 6-cylinder. Call your Mazda auto dealer's service department and ask for the location of this fuse.
Read the instructions that are in the new tstat box.
What is the cost to replace the head gasket on a Mazda MPV?
Replace it when it's dirty.
Mounted on top and inside the fuel tank.
By breathen inn
How do you replace a fuel injector on a 2001 Mazda mp
Replace the belt every 60,000 miles. Warning: This is an interference engine.
need to replace all my spark plugs on my Mazda mpv 2003 please help me.
For thermostat replacement step by step instructions with pics- http://www.pfyc.com/supportfiles/tstat/tstat.htm . "G"
The starter on a Mazda mph is on the left side of the engine. It is at the rear, against the bell housing.
I have a 1997 mpv with the same problem. I haven't started the repair yet but I am under the impression that a kit is available to replace the leaking seals. I have a shop manual for 1997 . I am willing to post the pages for those who need them.
How to Replace a head gasket on a 91 1.5 crx hv 5 speed?