answersLogoWhite

0

If your steering wheel is lock then it is tricky. Pry out the silver washer from the ignition key lock. Then you will need to cut the ignition switch cover with a hex saw. This process means you won't be able to use your key. You will need to get a new iginition key lock and key. If your steering wheel is not lock then you can save your lock and key. you need to put the key in run. This will match the notch on the cover and the lock. You need a special tool that has two prong that goes into the two notch. You can get it from Mercedes dealer. You should be able to pry the ignition lock and the cover out of its place.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Replace radiator on Mercedes 190e?

== ==


How do you replace the caburetor in a 1992 190e Mercedes-benz?

A Mercedes 190e doesn't have a carburetor. They are fuel injected.


Mercedes 190e 1985 window switch dead?

my 1993 190E 2.3 is doing the same thing. just replace the switches...they tend to not last


How do you replace the idle tensioner in a 1993 Mercedes 190e?

By using a tool box open the location and remove it to replace it with a new one


Where is the oil filter on a Mercedes Benz 1986 190E?

oil filter on a Mercedes 190E 1986 is in the back of engine


Are the headlights of a 1991 Mercedes 190E match with a 1995 Mercedes 220?

No they will not.


How much does a Mercedes-Benz 190e weigh?

A Mercedes-Benz 190e has a curb weight of approximately 3000 pounds. This varies by the year and configuration of the vehicle.


How do you replace the radiator bypass hose in a 1989 Mercedes 190E?

You can order the part at carpartsdiscount.com installation is easy. Just remove the clamps remove the hose replace the clamps with the new hose.


What is the length of a 1987 Mercedes-benz 190E?

10'5"


Where is the 1993 Mercedes 190e cabin filter?

There is no filter:)


How do you replace tensioner pulley on Mercedes Benz 190E?

To replace the tensioner pulley on a Mercedes Benz 190E, first, disconnect the negative battery terminal for safety. Then, relieve the tension on the serpentine belt using a wrench on the tensioner arm and remove the belt. Next, unbolt the old tensioner pulley from its mounting bracket and replace it with the new pulley. Finally, reinstall the serpentine belt, ensuring proper routing, and reconnect the battery.


How do you replace a ignition switch tumbler 1991 skylark?

how do you replace a ignitionswitch tumbler 1991 buick skylark